Rockboard MOD 3 V2 TRS & XLR Patch Bay

17

All-in-one patch-bay for pedalboards

  • Suitable for MOD Slots in RockBoard Pedalboards
  • Compatible with a wide range of other pedalboards
  • Acts as a central access point to the effect setup
  • Establishes clear cable routes to and from the pedalboard
  • Removable front panel for mounting on or under pedalboards
  • 3x 6.3 mm TRS thru
  • 2x XLR thru (male front / female rear)
  • 1x XLR thru (female front / male back)
  • 1x DC 2.1 x 5.5 mm hollow plug thru
  • 1x AC IEC thru (male front / female rear)
  • All connections mirrored on the rear side
  • Dimensions with front panel (W x D x H): 175 x 85 x 47 mm
  • Dimensions without front panel (W x D x H): 160 x 85 x 33 mm
  • Weight: 450 g
  • Includes mounting screws, lock nuts and TX wrench

Note: Register your product at www.w-distribution.de/Warranty and extend the warranty to 4 years.

Megjegyzés Register your purchase at www.w-distribution.de/en/Warranty for an extended warranty of 4 years.
katalógusunkba bekerült: Augusztus 2019
Termékszám 468599
mennyiségi egység 1 darab
27 990 ft
ÁFÁ-val, plusz 6 900 ft szállítási költség
Azonnal szállítható
Azonnal szállítható

A termék raktáron van és azonnal szállítható

Szállítással kapcsolatos tájékoztató
Szállítás megközelítőleg Szerda, 8.05. és Csütörtök, 9.05. közt.
1

17 Ügyfelek értékelései

4.6 / 5

A termékek értékeléséhez kérjük, jelentkezz be.

Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

kivitelezés

13 Vélemények

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
T
Total disappointment
TsalerA 30.08.2021
This is the reason of my bad evening.
Bought it to use with Rockboard pedalboard + Rockboard PSU. Looks cool, but that's all.
1. You have to do an screw-thread in the native pedalboard fof this thing by youself! Guys at the factory were very busy)) DIY!!!
2. It's patch-bay for the XLRs! Guess what?) XLR plugs do not fit in to the pedalboard holes!
3. Connected this thing to the native RB PSU. And it's very very noisy! Spend an hour looking whats the problem. It's this thing!!! Unpluged PSU fron this thing. connected PSU bypassing this thing, and it become less noisey!

Summary: This thing is patch-bay for xlrs, jacks and power.
You can not use this with XLRs and Rockboard pedalbords. You Can not use this with Rockboard PSU. This thing is useless. Waste of money(
kivitelezés
2
2
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
LR
I love it!
Love Rockboard 02.06.2021
Makes my board a lot neater and it looks cool too! Perfect for singer/guitarists (like me) or anyone that needs a few xlr ports on top of the normal jacks.
kivitelezés
1
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
CM
Extremely useful passive connections
Cian M. 23.12.2023
Needed this for a pedalboard build a few years back and have used it in a few different routing / signal chains since then.
The other rockboard patchbays look great too but this has the perfect connections for me. The Jack's being TRS for stereo or midi control is great. Makes routing a board with midi controls/foot controller so much neater and easier.
It is also nice for putting my amp foot switch, guitar signal and vocal mic outputs all within a few centimetres. Max setting up at the gig feel like no work at all.
kivitelezés
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
J
LOVE IT!!!
JinG 27.01.2024
ease of use and makes my board clean. using it for my rockboard quad 4.2. Thanks thomann!
kivitelezés
0
0
Jelentem!

Jelentem!