Millenium DB-118 Cymbal Boom Arm

109

Cymbal Boom Arm

  • 8 mm thread
  • Two cymbal holders - freely rotatable about 360°
  • Quick fasten lever mechanism
  • Tube 22 mm - Length: 31 cm
  • Boom 12.5 mm - Length: 32 cm
katalógusunkba bekerült: Június 2010
Termékszám 246957
mennyiségi egység 1 darab
with boom Yes
Incl. Memory Clamp No
19 890 ft
ÁFÁ-val, plusz 6 900 ft szállítási költség
Azonnal szállítható
Azonnal szállítható

A termék raktáron van és azonnal szállítható

Szállítással kapcsolatos tájékoztató
Szállítás megközelítőleg Csütörtök, 16.05. és Péntek, 17.05. közt.
1

109 Ügyfelek értékelései

4.5 / 5

A termékek értékeléséhez kérjük, jelentkezz be.

Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

kezelhetőség

stabilitás

kivitelezés

57 Vélemények

k
megbízható
kilgortrout 06.03.2024
Pancake drumot hordoz, és jól bírja
stabilitás
kivitelezés
kezelhetőség
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
J
What a great idea!
James4797 22.10.2015
For some reason it I can't believe I hadn't thought of it before- have 2 things off the bass drum. I use the third 'hole' on my yamaha double tom holder to have a stand for my splash cymbal, but this allows me to also use my tuned bell as well, without messing around with clamps and additional holders. This thing gives you loads of adjustability, took me a while to play around with it, but I got a really good position on both cymbals, and it is really sturdy without being really heavy. Of course, it is a millenium product, so it is half the price it would be from a mainstream brand, and less than you have already decided you wanted to spend.

I love this gadget, and I have to say that I am happy with all the millenium hardware I have bought. I am a seasoned drummer, and I point blank refuse to use sub-standard equipment, and neither am I a cheapskate! However, you will like the quality of this unit, and it saves carrying a load of extra clamps and brackets. Treat yourself!
stabilitás
kivitelezés
kezelhetőség
3
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
A very useful small cymbal stand
Anonim 15.11.2014
This is a very good piece of drumming accessories. I use it as a central stand on my bass drum (between the tom toms), and it fit my Yamaha holder just great. It is very sturdy and reliable and has a great looking finish. The product differs a little from the picture - the long black plastic handle is on both short cymbal tilts, and the central one (for the boom arm) is actually metallic. The handles are great for instant adjustments, and can be used to really tighten the screws quite easily. Obviously you can use the stand only for small diameter cymbals (about 10" on each side, or an 8" and a 12"). You should also consider the potential trouble with the central tightening handle since it can end up turned towards one of the cymbals when tightened, and since their tilts are quite short the cymbal can end up hitting the handle when struck.
If you're looking for a simple solution to put up your splashes or similar effects this is a great solution for you, just find a good place for it on your set.
stabilitás
kivitelezés
kezelhetőség
1
1
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
AH
Two in one?
Aki H. 12.11.2013
This one looked practical. I could put two effect symbals on same boom arm. Bar is wide enough to mount one 10" effect and one 12" effect, but setting this thing up was a bit problematic because of the black handle sticking up in the middle. Use smaller symbals to get a wider gap between them. Also, the positioning is quite hard because the arm tube is straight. If you use normal clamp and mount this thing on cymbal stand or tom holder, the cymbals are left too far. Solution is to use clamp that can be rotated, like Pearl AX-25 Multi Clamp. Anyways, despite few flaws the product is sturdy and well made.
stabilitás
kivitelezés
kezelhetőség
0
1
Jelentem!

Jelentem!