Jaspers MIK 964 Black

15

Adjustable Microphone Arm

  • With holder
  • For D-, V-, M- and S-stands
  • Black model
  • Length: 840 mm
  • With 3/8" connection thread, locking washer and handle
  • Secure clamping
  • A plastic sleeve protects tube from scratches
  • With holder to insert the arm into a vertical tube of the stand
katalógusunkba bekerült: December 2005
Termékszám 187594
mennyiségi egység 1 darab
Type Of Keyboard Stand Microphone Boom
Colour Black
20 290 ft
ÁFÁ-val, plusz 6 900 ft szállítási költség
Azonnal szállítható
Azonnal szállítható

A termék raktáron van és azonnal szállítható

Szállítással kapcsolatos tájékoztató
Szállítás megközelítőleg Szerda, 15.05. és Csütörtök, 16.05. közt.
1

15 Ügyfelek értékelései

4.5 / 5

A termékek értékeléséhez kérjük, jelentkezz be.

Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

stabilitás

kivitelezés

9 Vélemények

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
M
A little assembly advice
Matlow 07.02.2023
Great product, just little to no instructions. Therefore for those struggling a little - I used a sharp butchers knife to prise the cap off the vertical bar (you need something sharp to get between the cap and the bar), then used a mallet to get the boom arm stopper wedged in properly. Then tighten the nut on the stopper with a spanner, place the cap over the thread/nut, slide the boom arm out of the holder and screw the holder to the stopper as tight as it’ll go, then it’ll rotate smoothly with a bit of torque force from the reattached boom arm. Job done.
stabilitás
kivitelezés
2
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
MG
Works as Advertised but a bit short
M Gho 30.11.2020
I am using it with my Jaspers 2D-145B which is designed for 88 keys. At this width, the microphone arm is positioned around 1.5 Octave above middle C on my RD 700. If you place it on the smaller Jaspers stand, it should be positioned exactly in the middle
stabilitás
kivitelezés
1
0
Jelentem!

Jelentem!