t
ground contact is missing
contact for soldering the ground wire is missing. The best solution would be soldering the ground into the nickel plated case but this is somewhat complicated process. You need to use acid based active flux (rosin based flux wont work) and more powerful iron. Don't forget to clean the flux after the soldering, it contains acid and will corrode. Some people leave the ground wire unsoldered and use the pressure to make a ground connection but this can not be suggested for critical audio work.
2
0
Jelentem!
d
Can’t recommend
Only get this if you have no other choice, e.g. if the space is limited. There is no solder lug for the sleeve/shield, so you either try to solder it anyway or just let the shield get crimped when you screw the plug pieces together. Another big problem is quality. One of the plugs I bought wasn’t manufactured correctly in that the tip was loose and could be rotated together with its solder lug. O_o
1
0
Jelentem!
BE
Quality good but design not so
For all my patch cables I use the mono variant and couldn't be happier! The stereo ones however... You have two solderpoints, one L and one R but the earth has no real soldering contact and has to be pressed against the enclosure of the jack to make contact... which fails eventually... I swear by the mono ones for all my patch cables but the stereo is not recommended !
2
1
Jelentem!
A
Looks fancy
As I said in the heading, looks fancy at that was the main reason why I ordered these. I had two angled neutriks before but thew were way too huge.
Friend had some minor soldering problems but it went ok in general.
Friend had some minor soldering problems but it went ok in general.
1
0
Jelentem!
H
Well manufactured, highly reliable
I've setup a number of pedal boards, employing all sort of ancillary devices. These jacks are the right choice.
0
0
Jelentem!
DV
Best for your pedalboard!
I was searching a lot for the right jacks for my pedalboard and with Hicon jacks it was love from the first sight! It's very useful and it's very easy to make good cable management in your pedalboard with this jacks!
0
0
Jelentem!
L
Recommended for effects boards.
Good value - good connector, solidly made and contacts easy to solder, very useful for short cables linking effects on the my board. Neutrik are always my first choice for guitar cables but when space is restricted these Hicon are a safe alternative.
0
0
Jelentem!
J
Cool
Cool product, does what it should and looks fine!
0
0
Jelentem!
