EMG PA2

77

Preamp / Booster Circuit

For active and passive pickups

  • Suitable for guitars and basses
  • Boost 0 - 20 dB
  • 1 Mini switch circuit
katalógusunkba bekerült: November 2002
Termékszám 158344
mennyiségi egység 1 darab
27 990 ft
ÁFÁ-val, plusz 6 900 ft szállítási költség
Azonnal szállítható
Azonnal szállítható

A termék raktáron van és azonnal szállítható

Szállítással kapcsolatos tájékoztató
Szállítás megközelítőleg Péntek, 7.06. és Hétfő, 10.06. közt.
1

77 Ügyfelek értékelései

4.7 / 5

A termékek értékeléséhez kérjük, jelentkezz be.

Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

kivitelezés

40 Vélemények

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
2
I love this one!
23cm 12.01.2014
This is a great product for giving the guitar the extra bite and mids.

A word of advice: when installing this, don't set the boost at maximum (you'll understand what I'm referring to when you're there). I had it on max and it just made the guitar sound terrible and over distorted (much like the "loudness-mastering" on Metallica's Death Magnetic). Begin at 50%, try the guitar throught the amp and adjust upwards if needed.
Also, think about this before installing it: do you want it to activate when flicking the switch down or up? If you know that, you can put it in the right position from the start.
I wish I had this boost in all my guitars...
kivitelezés
2
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
RS
Great but you need an electronics background ....
ROY STONE 14.01.2020
These are brilliant ..... I find that because of the amount of abuse the wiring of the entire guitar takes, you have be able to fault find electronics to do these & be prepared to repeatedly dismantle Strat guitars, which have no easy access panels, just the complete front panel, meaning removing the strings then a complete rebuild to test it
kivitelezés
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
S
Great on-board booster
SteveRob 05.06.2015
I used this to provide the active boost for an Andy Summers replica Telecaster I built.

It did a great job; I moved the trim pot to a full-size pot to control the boost level just like on Andy's guitar.
kivitelezés
1
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
Needed it to blend passive and active
Anonim 18.03.2015
I got EM81 bridge and two passive.
So i needed a preamp for passives, because blending passive and active is a bad thing (tested it...horrible).
I used the other side of my selector for passives, and put PA2 at this side's output.
And soldered PA2 output and other side of selector output (EMG81 side) between them.

I put both PA2 and EMG81 at 18V (they handle up to 27V), and a 9V-18V switcher instead of tone knob (metalheads don't need tone knobs :D ).

Nice solution to avoid bypassing passive pickups or replacing them by active single coils.
kivitelezés
1
1
Jelentem!

Jelentem!