Doepfer A-110-2

29

Basic VCO for the A-100 modular system

  • Voltage controlled oscillator
  • 3-Position toggle switch
  • Linear FM input and soft-sync input
  • Tune control range can be set between approx. 1/2 octave and 4 octaves via a jumper
  • Width: 8 HP / 40.3 mm
  • Depth: 50 mm (measured from the rear of the front panel)
  • Power requirements: + 12V: 150 mA (warm up period about 30 seconds), 60 mA (continuous operation) -12V: 30mA
katalógusunkba bekerült: December 2014
Termékszám 354853
mennyiségi egység 1 darab
Analog Yes
Digital No
Width 8 TE / HP
variants Doepfer
50 790 ft
ÁFÁ-val, plusz 6 900 ft szállítási költség
Azonnal szállítható
Azonnal szállítható

A termék raktáron van és azonnal szállítható

Szállítással kapcsolatos tájékoztató
Szállítás megközelítőleg Kedd, 14.05. és Szerda, 15.05. közt.
1

29 Ügyfelek értékelései

4.6 / 5

A termékek értékeléséhez kérjük, jelentkezz be.

Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

kezelés

tulajdonsagok

kivitelezés

15 Vélemények

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
High quality, and surprising differences from A-110-1
Anonim 18.12.2015
The A-110-2 Basic Oscillator is a great-sounding oscillator, with interesting additions to the A-110-1 Standard Oscillator. While the -1 has a 5-position switch for octave, the -2 has only 3 positions. The -2 also sacrifices the sine output from the -1.

While the -1 has linear FM (i.e. a second 1V/Oct CV input with an attenuator), the -2 also has exponential FM. And while the -1 has a sync input, the -2 has both hard and soft sync inputs. The -2 has only one input for pulse width - but that seems like a reasonable sacrifice for the other features.

I find that the A-110-2 doesn't track as well as the A-110-1 in high ranges, and the sound is a bit "grittier" than the A-110-1. I actually like the square wave output of the -2 better than that of the -1, and since I have two of each, I tend to use them together to add texture to patches.

All in all, for the small price savings and the 2HP difference in width, I would tend to buy the -1 first - but I would buy a -2 to go with it, too.
4
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
KZ
Excellent !!
Kamil Z. 16.05.2016
Really great VCO it complements the Standard more expensive VCO very well. the soft sync is a must and differs a lot from hard sync, be careful though this unit is rather higly tuned and 0 pos does not correspond to 0 on the standard VCO, you can tune it down 2 octaves so no issues but will remain 1 octave above the lowest setting of the standard 110.

Higly recommended.
2
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
Good compact VCO
Anonim 15.03.2016
Affordable and compact which is good if rack space is a concern. I use it as an addition to my Arturia Microbrute but it sounds great even on its own with a few effects.
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
O
..is doepfer
Oskars 30.12.2016
Great features. Solid sound. Not a very shallow module.
0
0
Jelentem!

Jelentem!