Artec Power Brick

Very good entry level power supply that is definitely a must if you're using more than a couple of pedals in your chain. The box itself seems sturdy and should deliver enough power for the majority of pedals out there. LEDs on the side are a nice bonus that helps a lot in certain situations.

On the downside, selecting the variable voltages of 2 separate outputs with a pot feels a bit unreliable. However the greatest drawback in my opinion is the plastic low end power adapter and its cable supplying the DC 15V input to the Brick itself. The cable is pretty thin and it might be worth to wind a piece of tape or other form of protection around the parts of the cable subject to stress with frequent use as 15V adapters are not so common as 9 or 12V and you might find yourself in a tricky situation at the venue just before the gig. Also the hum cancelling doesn't work very well, probably due to cheap transformer inside the adapter.

All in all a great buy for the price and a no-brainer if you're struggling with multiple power adapters or daisy chaining. However if you have a little more to spend, I'd recommend a product with a standard mains power input and quality transformer.

I bought the Artec Power Brick because I was tired of using
a) batteries
b) a dasy chain
c) One power supply for each effect

I was a little afraid if the Power Brick could handle my different effects with differents voltages. Short answer: YES, it can!

It comes with a collections of different cables in different lenghts wich makes it really easy to access every effect on the board.

You can run up to 8 pedals with power supply
It has 1A max, 8x 9V/100mA and beside that 2x 6-12V flexible inputs.
With the short-circuit protection and hum elimination it is really usable.
It also has 3 LEDs wich could be quite bright and this could be really helpful on a darker stage.

I use it with a tuner, 2 Overdrives, a Wah Wah and a Tremolo without any complain.