Tovább az oldal tartalmához

Dante Audio Expander

  • 96 kHz / 48 kHz
  • In the design of a portable stagebox
  • 16 Mic preamps with XLR with status LED for phantom powering
  • 8 XLR Line Outs
  • Dante Primary and Secondary Ports with EtherCon
  • Operating modes redundant and switched
  • From dLive and SQ-Series direct access to the preamps possible
  • Rubber protection corners and carrying handle
  • AES67 compatible
  • Ready for Dante Domain Manager
  • 19" Rack kit optionally available
  • Dimensions (W x D x H): 399 x 189 x 182 mm
  • Weight: 4.75 kg
  • Suitable optional case: Art.504879 (not included)
  • katalógusunkba bekerült: Augusztus 2019
  • Termékszám 463186
  • mennyiségi egység 1 darab
  • Network Protocol Dante
  • Connector RJ45
  • Input Channels 16
  • Output Channels 8
  • Digital Inputs 2
  • Digital Outputs 0
  • Width 399 mm
  • Depth in mm 189 mm
  • Height 183 mm
  • Weight 4,75 kg
  • Mounting Height 4 U
  • 19" Rackkit Optional
B-stock áll rendelkezésre 826 957 ft-tól
893 601 ft
Minden ár ÁFÁ-val
Azonnal szállítható
1

4 Ügyfelek értékelései

4.3 / 5

kivitelezés

2 Vélemények

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
F
Analogue & +48v only for A&H Mixers
FiveLetterFruit 19.09.2024
A very nicely finished stage box. My Yamaha DM3 however is not fully compatible with the Analogue controls of the Pre-Amps, and requires external software to control A.Gain and Phantom Power switch.

Being new to Dante, I assumed pre-amp controls were a core part of the Dante protocol.

This makes it much harder to use when at a venue, and perhaps may cause issue when no laptop comes with you to a gig.

Other than keeping the A.Gain the same, and leaving +48v phantom power active all the time, I think I might be better off returning the unit for something fully compatible with my mixer.
kivitelezés
4
8
Jelentem!

Jelentem!