the t.bone Ovid System Bass Bundle

1

Bundle offer comprising

the t.bone Ovid System CC 100

  • Condenser Clip Microphone for Ovid System
  • Directional characteristic: Cardioid
  • Frequency response: 20 - 20,000 Hz
  • Flexible gooseneck for an easy instrument setup
  • 3-Pin Mini XLR connector for operation with t.bone wireless systems (also suitable for AKG wireless systems)
  • Gooseneck length: 130 mm
  • Cable length: 2 m
  • Easy to install and can be used with different instrument clips (not included, must be ordered separately)
  • Includes an XLR phantom power adapter (phantom power required) and a foam windshield

the t.bone Ovid System Bass Clip

  • Modular double bass microphone clip for Ovid systems
  • Easy to install without tools
  • Black rubber end caps protect the instrument from damage
  • Locking screw
  • Width 47 mm

the t.bone Ovid System Case

  • Plastic Case
  • With recess for all Ovid system microphone clamps and the CC 100 microphone
  • Outer Dimensions: 30 x 23 x 7.5 cm
Myynnissä vuodesta Toukokuu 2012
Tuotenumero 282626
Myyntierä 1 kappaletta
Microphone Set For Guitars No
Microphone Set For Drums No
Microphone Set For Vocals & Speech No
Microphone Set For Cameras No
Microphone Set For Wind Instruments No
Clip-On Microphone 1
Condenser Microphone 1
Näytä enemmän
82 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Maanantai, 13.05. - Tiistai, 14.05.
1

1 Asiakkaiden arviot

1 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

1 Arvostelu

google translate de
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
DF
Nicht praxistauglich
Dr. Fetti 17.12.2012
Der Halter sitzt zum einen nur wenig fest zwischen Saiten, was mit der Saitendicke noch zunimmt. Bei Darmsaiten oder den Fatblack von Gut-a-like bekommt man den Halter kaum montiert. Bei dünnen Metallsaiten à la Spirocore etc. ist das vielleicht ein geringes Problem. Das größere Problem ist, daß man mit der Halterung und dem Ovid-Mikro das Mikro aufgrund der Kürze des Schwanenhalses nur bis zur Decke bekommt. Die lautesten Stellen sind aber über den F-Löchern, die man von den Saiten zwischen Steg und Saitenhalter nicht erreicht. Ich habe dann mit zwei Klammern aus dem Baumarkt die Halterung am Steg festgemacht, was dann allerdings sehr gut geklappt hat und weshalb ich die Halterung nicht zurückgegeben habe.

Nachtrag: Nach geringer Benutzung hat sich von dem Gummi der Clip gelöst. Der Halter ging also schnell kaputt.
Työnjälki
7
12
Raportoi ongelmasta

Raportoi ongelmasta