Mooer Pedal Connector C

105

Patch plug for connecting effects devices

  • Version with slightly different connectors
Myynnissä vuodesta Helmikuu 2014
Tuotenumero 334936
Myyntierä 1 kappaletta
6,50 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Tiistai, 4.06. - Keskiviikko, 5.06.
1

105 Asiakkaiden arviot

4.4 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

50 Arvostelut

T
Don't buy these, for the sake of your pedals!
The_True_Meller 24.04.2020
Just no. These kind of plugs are the surest way of destroying your pedals in any frequent use. Although the connector is symmetric and you might think of saving real estate to your pedal board, it's extremely rare that your pedals' jacks would sit in perfect 90 degrees angle, not to mention on even height with each other. Usually this doesn't happen even with the pedals of same manufacturer, since there's usually at least a slight slant in the side of the pedal.

So, plugging two pedals together with this creates tension between the jacks, and this tension reaches into the circuit board inside. When stepping on a pedal, this tension is very, very bad news to the insides of the pedal. Eventually you WILL end up breaking your precious pedals with these. Yes, these are a tad better than the straight version, but the asymmetrical shape still does not prevent the tension between the pedals happening when stomped on.

They may seem to be a good idea on paper, but terrible in practice. Use patch cables instead, and if the space is that much of an issue, there are also flat jacked patch cables from few manufacturers.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
Good little connector for a compact pedalboard.
Tuntematon 26.08.2015
Okay, I will admit that when I bought these, I wasn't too bothered about how good they were because I intended to replace them not long after... When they arrived I had to check that I hadn't bought something better/more expensive accidentally, the units are nicely weighted, they don't feel cheap in their construction, the housing is sturdy and feels as if it will last a while, and they have to be strong for me to use them and they last longer than one gig.

Most will assume that the low price may be sacrificing audio quality, however I haven't noticed anything in the way of a decline in my tone, in fact, I have actually had a slight improvement in my top end response because I used the connectors to replace some fairly long and poor quality patch leads that caused clutter on my pedalboard (which got cleaned up by the use of these mooer "C" connectors)

All in all, a good little pedalboard clutter preventing device that also reduces cable length used in pedalboards (which can affect tone).
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
M
Great idea and nice implementation
Maksym 18.10.2020
This connector is useful if your pedals have different height. In case if you put pedals on the flat surface this is a perfect solution. If you are using a pedal board like Pedaltrain or Palmer Pedalbay, where you can hide your cables, I would consider the shortest flat patch cable instead.

Pros:
- high quality;
- pedals are nicely levelled;
- you do not have to mess with wires between pedals.

Cons:
- takes a bit more space between pedals than flat patch cables.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
Excellent quality
Tuntematon 23.03.2015
The connector is surprisingly heavy, which I think is a good sign that it is made to last and can survive anything. The width of the base is 20 mm. Excellent quality.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta