Sivun sisältöön

Jack

  • 4 - Pin 3.5 mm
  • With gold-plated pin
  • Maximum cable receiving 8.4 mm
  • Black housing
  • Myynnissä vuodesta Elokuu 2011
  • Tuotenumero 268945
  • Myyntierä 1 kappaletta
  • Build In No
  • Type TRRS
  • angled No
  • Plug Jack 3,5 mm TRRS male straight
7,90 €
Kaikki hinnat sis. ALV:n
Varastossa
1

77 Asiakkaiden arviot

4.3 / 5

Työnjälki

39 Arvostelut

t
Decent but not for repeated plugging and unplugging
tuokri 08.03.2025
I've broken the tip of two of these after a couple months of use, each. It's a pretty good connector but only if you don't need to repeatedly connect and disconnect it. The metal shell around the plastic pole seems thinner than it should be.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
M
Small and fiddly, but otherwise perfect
Matt.S 20.03.2020
Great quality connector for replacing the jack on headphones that include a microphone. Keep in mind when soldering that you'll need a pretty small tip to avoid melting the plastic. Also the sleeve for the cable is pretty big, a lot of modern headphones have ridiculously thin cables. So factor that in... Otherwise, great product.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
FF
Good quality and robust
Frank Flanagan 25.10.2021
Takes a decent size cable if you discard the rubber boot and replace it with thin heatshrink, which also probably provides better strain relief. I am using a bunch of these with 6.15 mm diameter cable.

You do need a fine soldering iron tip and ideally a decent wattage iron so the connector is only heated for a couple of seconds.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
TS
okey...
Tom S 03.04.2018
I used this jack to repair my earbuds.

I soldered the jack to my earbuds only i forgot to put the jack end on the cable before hand. So I had to desolder it the problem with that was that the plastic started to melt and 2 solder joints connected because of that.

Pro's
It's what it says it is

con's
weak design
Very large
1 chance to get it right
expensive
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta