Harley Benton Parts Push-Pull A250

20

Push-Pull Potentiometer

  • Mini potentiometer with DPDT switch
  • A 250 kOhm
Myynnissä vuodesta Syyskuu 2013
Tuotenumero 324122
Myyntierä 1 kappaletta
Design Push Pull
Resistance Value 2x 250 kOhm
Tandem Poti No
Push/Push Push/Pull
Solderless No
shaft type grooved
8 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu lähetyspäivä Perjantai, 26.04. mennessä
1

20 Asiakkaiden arviot

4.3 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

12 Arvostelut

MT
Good for pushing and pulling
Mat Thew 12.08.2022
Solidly working pot for push-pull installations. Installed this to my strat to do an extra pickup combination. Works great, not too tight, not too loose action.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
Sw
Works just as expected
Someone who likes it old-fashioned 29.12.2019
I installed this one into a Benton TE-20 to switch the bridge pickup out of phase, and it does so wonderfully. I have no regards to make about its push/pull functionality, it does so as expected. The one thing I would like to mention is that the shaft is a bit more loose than the previous pot I have on it, and the knob turns incredibly easily, more than I'd like to have on a Tele. I don't know if this is a more common thing with this kind of parts but it is something to mention: it wobbles just the slightest bit, and only if you tap it forcefully. Other than that: For the cheapest P/P potentiometer on Thomann with these specs, works wonders. I trust it to keep my tone knob working, although I wouldn't install it under a volume knob just because of how easily it turns.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
M
Didn't drive me potty
Martin6712 22.10.2014
I used two of these pots on my Yamaha RBX170 to allow me to switch my DiMarzio PJ pickups between parallel (higher output) and series mode (traditional).

They turn very freely and the push-pull switch has a nice clunk to it. Other than that they do the job just fine, tho' one of the pots is a little scratchy, but I expect some contact spray will fix that.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta