Harley Benton Ibanez bottom plate w/hook

4

Hook-and-Loop Base Plate for Ibanez Effect Pedals

  • OEM base plate with hook-and-loop fastener for attaching Ibanez pedals from the "9" series and Maxon effects pedals to pedalboards
  • Replaces the original rubber-coated base plate, which is not suitable for attaching the hook-and-loop fastener
  • Incl. hook-and-loop surface
Myynnissä vuodesta Huhtikuu 2023
Tuotenumero 554146
Myyntierä 1 kappaletta
7 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Keskiviikko, 26.06. - Torstai, 27.06.
1

4 Asiakkaiden arviot

4 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

2 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
J
Ruined a perfectly good Maxon OD9
JackB87 09.11.2023
Back plate sized incorrectly: does not fit the aperture of the Maxon OD9 (but specifies that it does). Screws are not the correct gauge and poor quality; far too tight.. two screw heads snapped off completely, leaving the screw shaft stuck and unable to be removed.. the back of the pedal is now incapable of being re-attached properly, and all four screw posts irreversibly damaged. Lastly, the HB plate does not provide the required battery compartment separation. Wish I had never bought this and just removed the rubber boot instead. Do not buy this product if you have a Maxon OD9.
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta