Doepfer A-120 Vintage Edition

10

24 dB Low Pass 1 (VCF1)

Module A-120 is a voltage-controlled 24 dB low-pass filter, which filters out the high frequency components from a sound spectrum while allowing the low frequencies to pass unhindered. The cut-off frequency (corner frequency) determines the point at which this effect occurs. They can be set or modulated both manually and via control voltages (filter modulation, with an LFO for example).

The VCF1 is configured as a "transistor cascade" with an edge slope of -24 dB / octave, which is also used in various Moog synthesisers, This results in the typical, "legendary" Moog sound. The resonance (emphasis) can be adjusted at the VCF 1 up to self-oscillation. In this case, the filter operates as a sinusoidal oscillator.

  • Vintage edition with black front panel
  • Voltage-controlled 24 dB low-pass filter
  • Black front panel
  • Width: 8TE / 40.3 mm
  • Depth: 65 mm (measured from the back of the front panel)
  • Power requirements: 30mA (12V) / -20mA (-12V)
Myynnissä vuodesta Maaliskuu 2016
Tuotenumero 383620
Myyntierä 1 kappaletta
Width 8 TE / HP
129 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu lähetyspäivä Torstai, 2.05. mennessä
1

10 Asiakkaiden arviot

4.8 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Käyttö

Ominaisuudet

Ääni

Työnjälki

8 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
EL
Moog ladder in Eurorack
Earl Langoustine 28.01.2021
This module gives you the classic Moog filter sound in Doepfer's 8hp format. If you've used one of the other Doepfer filter clones, you'll already have an idea of what this module is like. Of the three CV inputs, one tracks volt-per-octave and the other two come with attenuation. Resonance sounds very smooth and not piercing, as you would expect from this filter design, and also has input gain which seems to drive it. Pairs nicely within a larger Moog-style system - such as preceding this module with a CP3 mixer clone.

Important to note that these Doepfer filters are quite deep and will not fit in all skiffs (such as the Intellijel palette case). But on the positive, the currently listed specs above are wrong and the module is only around 55 mm deep (not the 65 mm listed above, the correct measurement is on Modulargrid).
Käyttö
Ominaisuudet
Ääni
Työnjälki
3
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
H
Get it
Hermanator 13.07.2021
I bought most of the Doepfer filter modules, and this is by-far my favorite. I didn't think that I'd like the bass response dropping off as resonance was increased, but I LOVE IT. I feel like this actually defines this filter. The adjustable sonic range on this is huge, when controlling level & resonance. I liked moog filters on softsynths & digital synths, but I LOVE this filter & authentic moog filters. There's a night & day difference between this & a digital emulation. It must be the way all of the transistors interact with one another as the resonance, level, and frequency is changed. Many digital emulations don't account for all of these minute differences. This thing really delivers. My only complaint, if any, are the knobs are a bit rough (hard on the hands to twist a lot). I'm tempted to replace them with a more comfortable knob, but I'd lose the classic look.
Käyttö
Ominaisuudet
Ääni
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta