Sivun sisältöön

Phantom power adapter

  • Selectable +12 / +48 V phantom power voltage
  • Suitable for all condenser microphones
  • XLR Female input (mic input) and XLR male output (mic thru)
  • Very low-noise sound
  • Including 12 Volt DC power adapter
  • Myynnissä vuodesta Maaliskuu 2006
  • Tuotenumero 191611
  • Myyntierä 1 kappaletta
  • Phantom Power Adapter and Feed Units No
  • Phantom Power Adapter No
  • Phantom power Yes
22,90 €
Kaikki hinnat sis. ALV:n
Saatavilla 8-10 viikon sisällä
1

301 Asiakkaiden arviot

4.6 / 5

Työnjälki

112 Arvostelut

M
Laatu phantom pienellä rahalla
Matti6048 04.08.2014
Erittäin kätevä ja pienikokoinen phantom virtalähde. Tekee juuri sen mitä pitää. Ei tule signaaliin mitään mikä ei siihen kuuluisi. 10+ pisteet.
Työnjälki
2
0
Raportoi ongelmasta

Raportoi ongelmasta

A
Näppärän kokoinen ja hyvin toimiva phantom-virtalähde
Tuntematon 27.01.2017
Kompaktin kokoinen laite, joka tekee kaiken minkä lupaa. Ainoa pienehkö miinuspuoli on laitteen oman 12V virta-adapterin virtajohto, joka on hieman "halvan" oloinen, mutta kestänyt käytössä ainakin toistaiseksi.
Työnjälki
0
1
Raportoi ongelmasta

Raportoi ongelmasta

T
Ok quality for nice price
Trb&tba 20.07.2017
Works fine for audio-technical clip mic.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
M
PS400 Phantomsupply: .....
MicroSoundLiker 14.04.2019
Just recently bought the PS400 for supplying phantom voltage to various condensor microphones. In brief: rugid built, however not meeting decent electrical specifications.
- Output voltage (unloaded) equals 12V in 12V-mode, but only 31V in 48V-mode, i.e. much too low! A short check of the internal electronic circuits shows a multi-diode trippler, thus limiting the output to 3x the input voltage, i.e. 36V max. It never will/can reach 48V, as claimed!
- The output voltage STRONGLY depends on microphone current drawing! E.g. in 12V-mode the voltage drops from its unloaded 12.0V to 10.4V (at 5 mA) and 8.5V (at 10mA).
But much more serious in 48V-mode: from 31V (unl.) to 22V (at 0.7 mA) and 12.5V (at 2 mA)! Note that common microphones typ. require 2-5 mA at 48V!
- Noise level is OK, both at 12V (adapter) as well as 9V (battery); at 9V unloaded output voltage is just 9V or 25V (select switch 12V- or 48V-mode).
Fazit: at "48V" setting the unit can not be used. Likely many people will be affected by this deficit, without knowing.
Työnjälki
10
2
Raportoi ongelmasta

Raportoi ongelmasta