Allparts Radiused Bone Nut F-Style UB

27

Grooved Bone Nut

  • With rounded bottom
  • For F-Style guitars
  • Unbleached
  • Dimensions (W x D x H): 42.9 x 3.2 x 6.4 mm
Myynnissä vuodesta Maaliskuu 2019
Tuotenumero 461454
Myyntierä 1 kappaletta
Width in mm 43 mm
Unmachined No
Instrument F-Style
7,90 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Keskiviikko, 22.05. - Torstai, 23.05.
1

27 Asiakkaiden arviot

4.4 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

16 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
HL
It says radiused but . . .
Howard L. 22.05.2019
A better description would have the EXACT radius. I was going to use this on a MIM Strat with a 9.5" radius but when I compared it to the factory nut there was no way it was going to work. I could be wrong but I'm pretty sure this nut is 7.25".
Työnjälki
6
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
T
Good quality, very easy to install
TERD 23.09.2022
This nut is made from good quality bone. The pre-shaped radius and guide slots made installation really fast. It was just a matter or slightly sanding the sides and then filing the slots to the correct height.

Be aware that Fender guitars can have either 7.25" or 9.5" radius and that many also need flat bottom nuts. If you buy pre-shaped nuts you need to make sure you get correct specs for your guitar.

Recommended.
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
M
its 7.25 radius
Metalex 10.09.2021
I bought it because of the radius, you can always shave off some by rocking it up and down on the sandpaper stuck to the fret board to make fit your fretboard radius. good quality.
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta