To the page content

Mojotone T 4-Way Prewired Harness

1.0 out of 5 stars from 1 customer ratings ()

Pre-Wired Electronics Replacement Kit for T-Style Electric Guitar

  • A kit comprising top-quality components, offering a significant improvement over standard electronics
  • Suitable for 2 single-coil pickups with 1 volume control, 1 tone control and a standard 3-way switch
  • Features a special 4-way switch which, in the fourth position, delivers a rich humbucker sound, whilst the other three positions retain the standard Tele switching functions
  • The treble bleed circuit prevents a loss of treble when the volume control is turned down
  • Switch positions: 1: Bridge, 2: Bridge and neck in parallel, 3: Neck, 4: Bridge and neck in series
  • Manufacturer number: Z457335-4S
  • Made in USA

Set consists of:

  • 2 Mojotone Custom CTS 250k solid-shaft potentiometers (9.5 mm thread length)
  • CRL 4-way switch
  • Switchcraft mono input jack
  • .047uf capacitor
  • Pre-tinned, fabric-covered wire
  • Volume mod (Treble Bleed)

Note: If the neck pickup has only two wires and a cover, a third wire must be isolate and added to the cover for the 4-way modification to work properly. It may also be necessary to lengthen the slot in the control panel so that the switch engages fully in the first and fourth positions.

  • Available since April 2026
  • Item number 642489
  • Sales Unit 1 piece(s)
  • Design Prewired Harness/Wiring Kit
  • Resistance Value 250 kOhms
  • Characteristic Curve Logarithmic
  • Thread Length in mm 9,5 mm
  • Tandem Poti No
  • Push/Push No
  • Solderless No
  • shaft type grooved
  • Type Switcher
  • Part Type Wiring Kit
  • Colour Silver
108 €
All prices incl. VAT
In stock
1

1 Customer ratings

1 / 5

quality

1 Review

google translate de
Unfortunately there was an error. Please try again later.
DE
Sehr ärgerlich
D.S. Esbo 27.08.2026
Das Mojotone T 4-Way Prewired Set ist grundsätzlich gut verarbeitet, doch bei meinem Exemplar hat sich erst nach dem Einbau gezeigt, dass der Switch nicht richtig funktionierte – ausgerechnet Stellung 4 funktionierte nicht. Klar, ich hätte natürlich zurücksenden können, das hätte aber zu lange gedauert (ich habe nur diese eine Gitarre). Daher habe ich mir einen neuen 4-Way-Switch besorgt und diesen eingebaut. Etwas ärgerlich, da ich das Set ja gerade gekauft hatte, um ums Löten herumzukommen. Ich gehe aber davon aus, dass es sich um einen Einzelfall gehandelt hat und nicht um ein grundsätzliches Qualitätsproblem. Auf jeden Fall passt jetzt alles.
quality
0
0
Report

Report