t
Great for D-mounting non-standard connectors
Drilled out to mount some BNC through-connectors into a rack panel.
These blanking plates are flat on both sides - no embossing or other moulding - so you can drill them out as required to mount other connectors that aren't otherwise supported in D-format panels. Use the Neutrik MFD mounting plates for a good strong mount of this blanking plate with your choice of connector. I used for BNCs but this approach would also work for jack sockets or RCA phono for example.
Use the Neutrik ones for a pro finish where you want a genuine blank (again use the MFD).
These blanking plates are flat on both sides - no embossing or other moulding - so you can drill them out as required to mount other connectors that aren't otherwise supported in D-format panels. Use the Neutrik MFD mounting plates for a good strong mount of this blanking plate with your choice of connector. I used for BNCs but this approach would also work for jack sockets or RCA phono for example.
Use the Neutrik ones for a pro finish where you want a genuine blank (again use the MFD).
0
0
Report