A
fine quality-good value
Works as it should be. I use it as tone pot. It seems to be more like a modern log taper (10% log), so it has a bit steep change of resistance. Total resistance value is close enough to stated value (about 1019 ohms). I would prefer it to have lower friction in order to turn easier. I play strats so i want pots to be loose enough so i can change value with my pinky. This pot is in the middle ground.
A fine product.
A fine product.
2
0
Report
NM
Good Boy
They say you can influence the brightness of the sound by changing the potentiometer value.
That's true... But 250kOhm, along with the highs, can eat up the gain and even the low frequencies of a humbucker.
So I decided to try 1000kOhm.
I have three popular values.
The Gotoh VK1-19 knob sits a little deeper on this potentiometer than the 250kOhm and 500kOhm ones from the same company.
Good quality!
That's true... But 250kOhm, along with the highs, can eat up the gain and even the low frequencies of a humbucker.
So I decided to try 1000kOhm.
I have three popular values.
The Gotoh VK1-19 knob sits a little deeper on this potentiometer than the 250kOhm and 500kOhm ones from the same company.
Good quality!
0
0
Report
D
CTS pots are worth the hype.
Used to upgrade my Squier J Mascis Jazzmaster, they're well worth it. The stock ones were a bit scratchy, and didn't have a nice taper, but these are just right, making the guitar feel a bit more like a proper Fender. No semblance of complaints here, for sure!
0
0
Report
Wa
Jazzmaster ready
These got my Harley Benton JA60 closer to the sound it is inspired by. It's almost like a lo pass filter is taken away. Great qual. pots
0
0
Report
K
Works fine
Nice taper. Requires the right amount of friction to turn it, not too loose, not too tight. Installed in in a Jazzmaster.
0
0
Report
m
Does the job!
Never had any issues with these
0
0
Report