the t.bone Lucan System CC 200 VH

35

Microphone Mount

  • Violin clip for the Lucan System CC 200 RC
  • Suitable for clamping to violins or similar instruments with a thickness of 32 to 50 mm
Myynnissä vuodesta Tammikuu 2021
Tuotenumero 500231
Myyntierä 1 kappaletta
Component type Clamp Mounting
19,30 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu lähetyspäivä Perjantai, 3.05. mennessä
1

35 Asiakkaiden arviot

4.5 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

21 Arvostelut

H
Works well
Hegetsu 07.05.2023
Stays in place. Seems sturdy enough. Sensible price.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
D
Very solid all metal mount
DaveScot 17.05.2023
This mount is very solid and re-assuring - you are sure that it will not fall off while in use. The only issue is that it does not quite grip the mic gooseneck perfectly - I had to add some electrical tape to prevent it rotating.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
T
Robust
Thpqqd 11.11.2022
Build quality is good and the thing stays put.

BUT it highly depends on the violin it's used on. Some violins have more curvature to the back than others and you might find it unusable on some violins. I did.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate de
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
SF
Studio Freak aus Berlin 09.07.2021
Hallo Thomann,
Die Halterung ist nicht optimal für Violine.
Man kann damit leicht die Decke zerstören.
Die Griffbügel sind zu lang für die Wölbung einer Geige.
Die Halterung eines Kinnhalter wäre optimal für Geige.
Das der Druck nur auf der Zarge liegt und nicht auf der Decke.
Työnjälki
4
0
Raportoi ongelmasta

Raportoi ongelmasta