Schatten Design MicroPre Preamp One Channel

12

PCB Preamp

  • Single channel JFET board preamplifier
  • Input impedance: up to 10 MOhm
  • Output impedance: less than 3.5 KOhm
  • Operating time with 9V alkaline battery: 1500 hours (not included!)
  • Operating time with 2 CR2032 button batteries totalling 6V: 750 hours (not included!)
  • Dimensions: 28.5 x 18.5 x 4.5mm
  • Includes belt clip
Myynnissä vuodesta Toukokuu 2020
Tuotenumero 492749
Myyntierä 1 kappaletta
39 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Maanantai, 6.05. - Tiistai, 7.05.
1

12 Asiakkaiden arviot

4.9 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Ääni

Työnjälki

10 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
G
Does the job at a low cost
Guruniverse 30.01.2023
My 40 year old preamp in my Ovation 1618 12 string had gone bad. I found the original Ovation replacement part to be ridiculous expensive. The MicroPre in combination with a stacked potentiometer is a very cost effective alternative, provided you are not scared using a soldering iron.

Installation: instructions are available online. For me a huge plus, cause it allows you to assess it pre-purchase. Diagrams are well documented and showing different installation options (volume only, volume + tone control). If you know how to solder, you can install it. Only downside is that the instructions don not include the tech specs for the volume/tone potentiometers and tone capacitor. Based on the pots sold by Schatten seperately I figured out that both volume and tone pot need to be 500K Ohm log versions. The tone capacitor needs to be 47nF.

Sound: Sounds good to me for live playing. I could not notice a significant difference between the original one and this one.
Ääni
Työnjälki
4
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
m
Go -to Preamp for simple Piezo installation
mjxguerra 27.05.2021
I've tried a number of eBay preamps for piezo installations and for which a Fishman is usually the 1st choice, however for installing a piezo under the saddles of a Vegatrem on a Strat I needed something really compact that would fit in the control cavity. The simple, compact Schatten single channel preamp-on-a-chip is functionally not as clever as a multi-control Fishman installation, but it is super compact, works and blends well with the magnetic pickups.
Ääni
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
MW
Great drop-in solution
Maks Wu 03.08.2023
I've had an ukulele with a broken preamp and a piezo pickup, and this basically solved all my troubles. Great quality, simple installation with proper instructions, and above all, clear sound.
Ääni
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta