Evästeet auttavat meitä tarjoamaan sinulle parhaan mahdollisen ostokokemuksen. Ne auttavat meitä muistamaan asetuksesi ja evästeiden avulla pystymme myös tarjota sinulle sopivia tuotteita. Paina ” Hyväksy”, niin sallit meitä käyttämään evästeitä tilastointia ja markkinointianalyysiä varten (näytä kaikki). Voit hallita yksityiskohtia ja asetuksia täällä. Voit peruuttaa suostumuksesi milloin tahansa evästeasetusten kautta (täältä).
Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.
Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.
Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.
Does what it's supposed to do, don't waste money on expensive blanks!
Tuntematon 05.02.2017
This is good for when you need to fill a blank in your breakout box, for example. Easy to install and remove if needed. No need to spend more money than this on a blank. It's inconspicuous and neat and gets the job done.
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
t
Great for D-mounting non-standard connectors
thelxman 21.11.2020
Drilled out to mount some BNC through-connectors into a rack panel.
These blanking plates are flat on both sides - no embossing or other moulding - so you can drill them out as required to mount other connectors that aren't otherwise supported in D-format panels. Use the Neutrik MFD mounting plates for a good strong mount of this blanking plate with your choice of connector. I used for BNCs but this approach would also work for jack sockets or RCA phono for example.
Use the Neutrik ones for a pro finish where you want a genuine blank (again use the MFD).
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
LA
Just what I needed
Leo Audioworks 03.12.2020
I went for these over the Neutrik ones, and I'm glad I did. They're cheaper, made from plastic, but since they're just a blanking panel, they don't need to be anything else, and when mounted from the back, it's completely flush with the panel itself, giving a nice, clean look.