Millenium Guitar Clothes Rail Hanger

Puedes colgar tus guitarras directamente a tu armario, por lo que te ahorras que tus guitarras cojan polvo en los stand. Además de ser un aliado para los que sufren G.A.S. y no pueden parar de comprar y vender guitarras.
Su fabricación es muy buena. No daña la guitarra ya que donde se apoya, que es en la union del mastil y clavijero, lleva un refuerzo blando.
Soporta perfectamente el peso y la parte del enganche es robusta.
El apoyo donde se cuelga la guitarra además gira por lo que se adapta a varios formatos y medidas de clavijero.
No tengo dentro de mi colección guitarras de 7 u 8 cuerdas por lo que desconozco si la medida acepta estas guitarras.
También tengo un producto similiar de mayor precio y este cumple de la misma manera que los otros, por lo que es un producto que recomiendo.

I hung it on iron bars I have as room separators.
Work very well. I purchased 22, and am very satisfied.

The hook is wide enough to hang from most sizes of bars, so I can't imagine there being any sort of an issue in that regard.
Further, if you wish, it could also work as a great installation if you fixate a hook onto the roof, and but this hanger on it. The guitars would float above, would look great.

10/10 recommend.
It is also much cheaper here than on Amazon.

I have "a lot" of string instruments, so I needed a solution to hang them, no free wall available. I thought of a mobile "wardrobe" and self-made hangers, a piece of hardwood with a hole for the rail, and a pair of pins (steel with rubber coating) that would fit into a few holes in that little plank. Cheap, but quite some work, even in my fully equipped workshop. I saw these Millenium hangers and ordered 20 of them, enough for the 2.5m long rail. They are great, even though I might shorten a few to gain space below the instruments, where I will store my pedals (a few dozen). I will check the diameter of the steel wire used for the hangers, and, if possible, I will cut one, make it a bit shorter and thread it, after which I will rejoin both parts with a junction nut. Note that I still have to make the rail stand, a 250x45cm board on 5 wheels (one in the middle, given the length), an edge profile formed from hardwood, two 145cm high aluminium profiles and 2.5m galvanised plumbing pipe (3/4") should do the trick. Some triangular foot pieces and black paint (epoxy for the pipe and profiles) should finish the job.