Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
RS
Excellent Value For Money
The Studio Rack 16U 38 is currently in my studio holding the few pieces of rack gear currently in use. It's well built and came also fully built, no assembly required.
Most importantly it does have enough room to fit things on top, currently it's doubling as a stand for the studios Access Virus TI2 Polar.
The only downsides were that not enough nuts were provided, it was enough for 1 unit however there were more than enough bolts and washers which was a little weird. Thomann were really helpful and supplied some more. It's a small thing but pair of racks on the back would have made this super killer. Just incase I wanted to install cable management systems or make it neater and panel up the back.
Still don't regret buying it, looks lovely and it's very sturdy.
Most importantly it does have enough room to fit things on top, currently it's doubling as a stand for the studios Access Virus TI2 Polar.
The only downsides were that not enough nuts were provided, it was enough for 1 unit however there were more than enough bolts and washers which was a little weird. Thomann were really helpful and supplied some more. It's a small thing but pair of racks on the back would have made this super killer. Just incase I wanted to install cable management systems or make it neater and panel up the back.
Still don't regret buying it, looks lovely and it's very sturdy.
0
0
semnaleaza un abuz
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
A
Low cost but high quality
I have purchased a number of the thomann studio racks over the years for installations. I find the racks very well made. I have used these for a mixture of AV installs andf IT installs where lower cost racks are required.
0
0
semnaleaza un abuz
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
i
just the ticket
Cheap and cheerful rack for studio use as has no front or back covers for transportation. Seems perfectly up to the job, if a little wonky when empty...lots of nuts and bolts supplied and a rubber strip in the rails to stop the nuts falling when vertical - this can be annoying with this type of rack if you have to take a unit out say for repair and later find your nuts have dropped.. has feet too.
2
0
semnaleaza un abuz
