TAD SC-Style Long Shaft Wiring Kit

Start 360°

Arată traducerea

Electronics Set for SC-Style Electric Guitar

High-quality components provide a considerable improvement over standard electronics
Switch positions: 1: bridge, 2: bridge & neck, 3: neck
Made in USA

included in delivery

Volume control: 2 x CTS 500 kOhm, Long, Vintage Audio Taper (30 %), fine grooved slotted axle (24 teeth for US guitars & pot knobs)
Tone controls: 2 x CTS 500 kOhm, Long, Vintage Audio Taper (30 %), fine grooved slotted axis (24 teeth for US guitars & pot knobs)
Capacitors: 2 x Sprague Orange Drop .022µF
Switch: Switchcraft Toggle Switch
Jack socket: Switchcraft

Cable:

170 cm 2-core with braided shielding
50 cm tinned copper wire

disponibil din Mai 2023

numărul articolului 567199

unitate de vânzare 1 bucată(ăţi)

Design Normal

Resistance Value 500 kOhms

Characteristic Curve Logarithmic

Thread Length 19,0 mm

Tandem Poti No

Push/Push No

Solderless No

shaft type grooved

Type Switcher

Colour Chrome

Mai mult

389 lei

Include TVA la care se adaugă 89 lei costul de transport

166

Nivel de vânzări

în Potenţiometre

2 Evaluările clienților

5 0 Clienți 4 0 Clienți 3 0 Clienți 2 1 Client 1 1 Client

1.5 / 5

Măiestrie

Recenzii ghiduri

2 Recenzii

Arată traducerea

Arată originalul

Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.

High quality pots, medium quality wire and not enough washers

Guruniverse 13.09.2023

Bought the kit to install into my Gibson Les Paul Classic, as the previous owner had installed a solderless EMG active set (25K pots) and I wanted to revert to passive again.

Pots are decent CTS quality and have a nice solid feel without being too tight. The single core braided wire has a plastic insulation layer as opposed to the more traditional waxed cloth insulation. You must be very careful not to overheat the outer braided wire, because it will melt the inner core and create shortages. This can be quite tricky as the braided part often needs to be soldered to the solid part of the pots, requiring quite some heat close to the melting point of the inner core. I failed on one of the leads, but fortunately there was sufficient braided wire supplied to solder a new one.

As these are pots with long shafts, you will usually need to adapt the spacing from the inside of the cavity in order to make the pot meter protrude the right amount on the outside. This requires a washer on both the inside and outside of the guitar. However, only a single washer was supplied per pot, so I had to order some additional washers separately. As this stalled the installation and increased the cost and effort to find the correct washers (you will need the 3/8” version), it was a huge disappointment.

Conclusion
Pros: Pots are high quality, sufficient wire supplied
Cons: Braided wire core is plastic and prone to overheating, it should contain 4 additional washers.

semnaleaza un abuz

Consideraţi această evaluare inexacă sau inacceptabilă din anumite motive? Vă rugăm indicaţi motivul părerii dvs în următorul câmp – dacă e posibil – adresa de e-mail pentru întrebări suplimentare.

Citește toate recenziile

TAD SC-Style Long Shaft Wiring Kit

Electronics Set for SC-Style Electric Guitar

2 Evaluările clienților

Pentru a evalua produse trebuie să fiţi logat.

2 Recenzii

smart navigator

Produse vizualizate recent

Cumpărați și plătiți în siguranță

Beneficiile tale

Service

Servit cu dragoste!

TAD SC-Style Long Shaft Wiring Kit

Electronics Set for SC-Style Electric Guitar

Accesorii și articole compatibile

2 Evaluările clienților

Pentru a evalua produse trebuie să fiţi logat.

2 Recenzii

Compară opțiunile

smart navigator