La conținutul paginii

Millenium Guitar Clothes Rail Hanger

4.9 din 5 stele din 29 evaluări ale clienților

Guitar Holder

  • For hanging guitars and basses on clothes rails
  • Suitable for all standard headstocks
  • Total length: 310 mm
  • Depth: 100 mm
  • Width: 82 mm
  • Maximum neck width: 50 mm

Note: not suitable for guitars with nitro lacquer.

  • disponibil din Iunie 2020
  • numărul articolului 489622
  • unitate de vânzare 1 bucată(ăţi)
  • Material Steel
  • Type Hang
  • Suitable For: Acoustic Guitar, Electric Bass, Electric Guitar
  • For Instruments with Nitro Lacquer No
35 lei
Toate prețurile includ TVA
în stoc
1

29 Evaluările clienților

4.9 / 5

Stabilitate

Măiestrie

25 Recenzii

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
K
Saved my wall!
Kamui 28.04.2021
I hung it on iron bars I have as room separators.
Work very well. I purchased 22, and am very satisfied.

The hook is wide enough to hang from most sizes of bars, so I can't imagine there being any sort of an issue in that regard.
Further, if you wish, it could also work as a great installation if you fixate a hook onto the roof, and but this hanger on it. The guitars would float above, would look great.

10/10 recommend.
It is also much cheaper here than on Amazon.
Măiestrie
Stabilitate
1
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
m
Perfect for me!
mnoach 23.09.2023
I have "a lot" of string instruments, so I needed a solution to hang them, no free wall available. I thought of a mobile "wardrobe" and self-made hangers, a piece of hardwood with a hole for the rail, and a pair of pins (steel with rubber coating) that would fit into a few holes in that little plank. Cheap, but quite some work, even in my fully equipped workshop. I saw these Millenium hangers and ordered 20 of them, enough for the 2.5m long rail. They are great, even though I might shorten a few to gain space below the instruments, where I will store my pedals (a few dozen). I will check the diameter of the steel wire used for the hangers, and, if possible, I will cut one, make it a bit shorter and thread it, after which I will rejoin both parts with a junction nut. Note that I still have to make the rail stand, a 250x45cm board on 5 wheels (one in the middle, given the length), an edge profile formed from hardwood, two 145cm high aluminium profiles and 2.5m galvanised plumbing pipe (3/4") should do the trick. Some triangular foot pieces and black paint (epoxy for the pipe and profiles) should finish the job.
Măiestrie
Stabilitate
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
A
Works Suprisingly Well
Anonim 18.10.2023
I bought it to hang my bass within my wardrobe, I was not expecting it to work as well as it does, but it was cheap enough to try.
I am glad to say that it is very stable and it is a great value for the money.
Măiestrie
Stabilitate
1
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
SL
Bolji od svog jeftinijeg brata
Sive Lubanje Silom 08.02.2022
Zanimljiva ideja. Baš ono što mi je trebalo za sobu gdje ne smijem bušiti, a imam dosta mjesta za objesiti bas. Ide na dosta toga i može se podesiti. Nisam naišao na slične proizvode u hrvatskim dućanima. Bravo Thomanne!
Măiestrie
Stabilitate
0
0
semnaleaza un abuz

semnaleaza un abuz