Artec SE-2A Bass Electronic Set

108

Bass Electronics

  • With 2-band EQ on tandem knobs
  • To connect to active or passive pickups
  • 3 Knobs for treble - bass and tandem (volume)
  • Bass: +/- 12 dB @ 100 Hz
  • Treble: +/- 12 dB @ 4 kHz
  • Matching potentiometer knobs: art. 339884 and art. 339886 (not included)
disponibil din August 2004
numărul articolului 172727
unitate de vânzare 1 bucată(ăţi)
Equalizer 2-Band
117 lei
Include TVA la care se adaugă 89 lei costul de transport
în stoc
în stoc

Acest produs e disponibil în stoc și poate fi expediat imediat.

Informații despre livrare
Expediere preconizată până Marţi, 30.04.
1

108 Evaluările clienților

4.1 / 5

Pentru a evalua produse trebuie să fiţi logat.

Reţineţi: Pentru a preveni evaluările bazate pe zvonuri sau reclame ascunse permitem doar evaluări de lşa clienţii noştri reali, şi care au cumpărat echipamente de la noi.

După logare veţi găsi de asemenea toate articolele care pot fi evaluate Centrul Logare Clienţi.

Sunet

Măiestrie

75 Recenzii

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
W
Preamp good but watch the wiring
Woodinblack 17.01.2018
I fitted this on a previously passive Iceman bass. The shafts of the pots aren't long, so I had to do a bit of woodwork and the width of the dual concentric tone control is bigger than a normal tone knob, so the hole needed to be rewired. They give you a good amount of cable to position the battery.

I had a problem in that after grounding the bass, it no longer made any noise and found out that the wires that went from the balance output to the tone input were reversed which was shorting out the board. Taking the pins out of the plug and putting them in correctly (as the silk screen on the board shows) fixes the problem. Also note that there are no instructions with these preamps, although instructions are on artecs website. Everything is wired (even if incorrectly) apart from battery +/- and jack out/ground/switch solder terminals on the board.

Apart from the wiring issue, which is why I marked quality down, the actual quality of the preamp is fine, I can hear no difference with it in or out of the circuit with the tone controls flat, as it should be, and the tone controls provide a useful range of options.
Sunet
Măiestrie
3
1
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
C
Good upgrade!
Cesar593 13.10.2017
This is a noise free, reliable and very well built active preamp for bass guitar! I have used it to replace a noisy preamp in an older bass, and I am very satisfied! Not only did the noise disapear, but it now sounds louder and deeper. Don't be fooled by the price, this is a great preamp! Best for the buck out there, no doubt about it!
Sunet
Măiestrie
5
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
S
Transparent when you work out why it's flawed
Sethguitarman 10.12.2022
So initially I thought this preamp sucked the tone massively from my musicman style pickup, making it quite boxy / dead. Then I realised that at centre detent the EQ is actually sucking half the bass and treble out of the mix. When both hi/low are at 100% my pickup was back to sounding as it should (with a nice quiet transparent boost). So really you need to leave it at 100% and the roll back the bass for a treble boost, and roll back the treble for a low pass. A proper designed preamp should be effectively bypassed at the middle position, this is not. hence the three stars.

However when you know this it can be used quite effectively, if you're good at soldering the stacked potentiometer can be replaced with two seperate hi & low pots. The volume control is very smooth and linear which is great.
Sunet
Măiestrie
1
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
A
boosters on...
Anonim 11.07.2015
splendid piece of kit.
this brings a bit more life into the old axe, it does however highlight any earth issues and pick up wiring conflicts.
my aria p2 has a single and hum bucker, they had to be wired in reverse of there original wiring which brought to my attention earthing problems....simple, need new pickups. bummer.
enhances the basses top mid and bass with a real difference.
the blend button is a bit harsh and doesn't really give a lot of range and it wont work full stop without a battery... keep a spare at hand.
real easy to fit and im sure once you got through the positioning and wiring you'll be reasonably impressed. I am.
Sunet
Măiestrie
1
0
semnaleaza un abuz

semnaleaza un abuz