M
Usable but not great.
The problem is that this shielding doesn't have conductive adhesive.
That means that each time you cut and overlap two pieces, the connection between the pieces is not made. Then you need to solder each part together which is not convenient at all.
I will use it as a single piece for a smaller pickguard, or the cavity cover so it's not completely useless.
It would be useful if the description says that adhesive is non conductive.
That means that each time you cut and overlap two pieces, the connection between the pieces is not made. Then you need to solder each part together which is not convenient at all.
I will use it as a single piece for a smaller pickguard, or the cavity cover so it's not completely useless.
It would be useful if the description says that adhesive is non conductive.
4
0
Report
Nt
Aluminium shield
It was ok, easy to install but I haven't notice any difference
0
0
Report
j
A bit too small
It goes fine, but if you need to shield a stratocaster, you'll need two of these.
0
0
Report
D
Good material
Good foil and shielding with this does work, but just be aware that the adhesive is not conductive.
0
0
Report