Evästeidemme avulla haluamme tarjota sinulle parhaan mahdollisen ostokokemuksen kaikkine siihen liittyvine yksityiskohtineen. Tähän kuuluvat esimerkiksi sopivat tarjoukset, personoidut mainokset ja mieltymysten tallentaminen. Jos tämä sopii sinulle, hyväksy vain evästeiden käyttö tilastoja ja markkinointia varten klikkaamalla ”Selvä!”. (täällä). Voit peruuttaa suostumuksesi milloin tahansa evästeasetusten kautta (täältä).
Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.
Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.
Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
ST
If you still have broken just-a-nut 2...
Sergio Tlm 20.01.2022
Of course i wanted gold one made of brass. But i have completely black Vampyre Sn. So here we go. Basically it resembles stock just-a-nut 2 that had unreliable side holder wings, that tend to brake. Version # 3 has this issue fixed.
There is also step-by-step replacement tutorial on youtube.
p.s. Doublecheck your bass nut width as it comes in two or three various dimensions.
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
M
Perfect Fit!
MPullin 11.01.2022
Ahustable nut! Is anyone else is doing this?
Having the luxury of being able to adjust the nut height is just brilliant. I can tweak it to match different playing styles and don't have to worry about sanding it down to fit... The beauty is even if you did sand it down and went a little too far, you can quickly raise it back up. Lovely!
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
Great alternative to standard bass nuts
Tuntematon 28.03.2017
These Tedur Just a Nut IIIs are a great upgrade over standard plastic and bone nuts on most bass guitars. They are easy to instal and their design means you can set the nut height action very easily with a small allen key rather than hack away at your nut with a file!
If you change you string gauge in the future you can then just re-adjust the nut height rather than having to get the file out again.