Evästeidemme avulla haluamme tarjota sinulle parhaan mahdollisen ostokokemuksen kaikkine siihen liittyvine yksityiskohtineen. Tähän kuuluvat esimerkiksi sopivat tarjoukset, personoidut mainokset ja mieltymysten tallentaminen. Jos tämä sopii sinulle, hyväksy vain evästeiden käyttö tilastoja ja markkinointia varten klikkaamalla ”Selvä!”. (täällä). Voit peruuttaa suostumuksesi milloin tahansa evästeasetusten kautta (täältä).
Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.
Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.
Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
N
Handy little boxes
NyquistAudio 24.09.2018
Nice sturdy build quality. These were a great solution for me. I'm using these to get extra returns down a single cat5 run for 2 stereo IEMs - going from a console into a Samson S-phone headphone amp to drive Fischer beltpacks in stereo. Unbalanced input on the headphone amp, but these boxes give me a balanced run, and eliminated problems I had with lighting dimmer buzz.
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
j
An eye opener
janusM 13.08.2023
This quad ballun really does the job. I used it with 25m of cat6 cable. But when testing (still coiled) I picked up some hum. So I modified it by soldering a ground wire on the casing of the internal RJ45 female connector in on of the 2 boxes. Perfect sound now !
I will also solder myself some balanced cinch-XLR cables (pin 1 unconnected), so that I can send microphone signals through this wiring.
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
S
Not Compatible with the the sssnakeCat Snake 3M series
SEGFAULT 25.11.2024
If you are in the position I was in, wondering how to connect a tape deck "all the way over there" to a mixer "over here" then you may have wondered if you can connect this to a the sssnakeCat Snake 3MC
the sssnake Cat Snake 3MC to get RCA to XLR via a balanced CAT cable.
If you are like me you may have figured out friom the manuals that to have a chance of working you need to open the unit and swap around two connections so the pinouts match.
I am here to tell you that doesn't work. The impedance mismatch between the transformer and the input of your XLR interface is too high for a passive system to overcome. The resulting audio is thin and tinny.
If you buy a second one and use it as intended it works great (although a little pricy for what it is)