Sivun sisältöön

Machine Head Set for Electric Bass

  • F-Style
  • Style: 4 Left
  • Bore: 18.5 mm
  • Gear ratio: 1:22
  • Surface: Nickel

Hole spacing on the base plate:

  • Narrow side: 20 mm
  • Wide side: 26 mm
  • From top to bottom: 34.4 mm

Dimensions of base plate:

  • Length: 45.3 mm
  • Width 1: 33.35 mm
  • Width 2: 27.2 mm
  • Myynnissä vuodesta Joulukuu 2019
  • Tuotenumero 480068
  • Myyntierä 1 kappaletta
  • Colour Nickel
45 €
Kaikki hinnat sis. ALV:n
Varastossa
1

40 Asiakkaiden arviot

4.8 / 5

Työnjälki

32 Arvostelut

N
Great upgrade for Affinity P Bass
Niveler 03.01.2025
Cheap and good upgrade tuner set for my Chinese Affinity P Bass.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
M
Put them on an old neck. Great tuners!
Muziekschuur 10.12.2020
The good stuff! Nuff said. Thomann sells them. Get some.
Tune up and rock out.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
J
Good budget replacements
Jezzaboy 18.04.2020
Cheap tuners are part of the reason some basses are lower price. You cannot spend £300 and expect USA quality. Usually I would buy a set of Schaller tuners as they are my favourites but they are about £70-£80 delivered.

I recently picked up a cheap Squier and thought I would try the Kluson tuners to keep the cost down. They are quite good and keep the vintage look I was looking for. I still prefer my Schaller`s but for a budget bass, these do the trick fine.
Työnjälki
3
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
M
Tuners ok, screws are very bad
MicDecorte 18.02.2026
The tuner mechanisms appear to be of good quality.

However, the screws are of very poor quality. If you want to buy these tuning mechanisms, you should also buy different screws. Three of the screw heads broke off when I used them. I had pre-drilled the holes. Two screws broke off before I could tighten them. One screw broke off while I was tightening it.

I am going to replace the screws because I don't trust that they will stay tight in the future.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta