Schoeps Microphone Accessories
35 results. Displaying items 1–25.
The prices shown include VAT. Free Shipping Over 49 €
Microphone Amplifier CMC for MK Series CapsulesThe microphone amplifiers CMC are not amplifiers in the classical sense. Their task is rather to adapt the signals of the high-impedance condensate capsule for the very low-impedance, balanced transmission through the microphone cable....
- Power supply for capsules of MK series
- Power supply by 12V - 48V phantom power
- With balanced, especially low-impedance output
Microphone Outdoor Protection Consisting of wind shield R1 and W 20 R Wind protection basket W 20 R, Wind noise attenuation at 18 km / h with balls 43 dB-A, with a supercardioid 51 dB-A, Diameter: 90 mm, Colour:...
- Consisting of wind shield R1 and W 20 R Wind protection basket W 20 R
- Wind noise attenuation at 18 km / h with balls 43 dB-A, with a supercardioid 51 dB-A
- Diameter: 90 mm
Hollow Foam Popscreen B 5 D For use especially on pressure-gradient transducers in light wind and as a close-speech guard. The B 5 D offers good effectiveness, yet has only a slight influence on the sound. It is made...
- Dimensions: 70 × Ø 50 mm (max)
- Colour: Grey
- Additional gray flocking
WindshieldHighly effective wind shield for pressure gradient and pressure receivers with low sound effects. The foam hollow sphere encloses an air volume around the capsule, similar to a wind protection basket. Particularly when using CCM-L, care must be taken that...
- Dimensions: ball with Ø 90 mm
- Colour: Black
- Additional black flocking
Stand ClipThis tripod clip with joint has a foot with a 5/8 "-27 NS internal thread. Thanks to the supplied adapter, it can be screwed onto any type of tripod with 3/8" or 1/2" etc. The inclination of the microphone...
- With joint
- For microphones with a diameter of 20 mm
Microphone AmplifierThe CMC 6 xt is a special version of the phantom-powered microphone amplifier...
Microphone AmplifierThe CMC 6 xt is a special version of the phantom-powered microphone amplifier CMC 6. Connecting one of many microphone MK capsules of the SCHOEPS module system into the amplifier creates a complete microphone. It can operate...
- With extended frequency response up to 40 kHz
- For capsules from the MK series
- Powered by 12V - 48V phantom power
Active Extension Tube
Active Extension Tube Length: 1200 mm, Colour: Anthracite, Tube swivel RG 8 included
- Length: 1200 mm
- Colour: Anthracite
- Tube swivel RG 8 included
Windscreen Made of nylon fabric for the CMC series, Two separable halves, Wind noise attenuation at 18 km/h with omni-directional microphones 29 dB-A, Wind noise attenuation at 18 km/h with super-cardioid capsule 38 dB-A, Diameter: 80 mm, Colour: Light...
- Made of nylon fabric for the CMC series
- Two separable halves
- Wind noise attenuation at 18 km/h with omni-directional microphones 29 dB-A
Foam Windscreen Suitable for CMIT 5, Wind noise attenuation at 18 km / h 18 dB-A, Length: 140 mm, Diameter: 41 - 50 mm, Colour: Anthracite
- Suitable for CMIT 5
- Wind noise attenuation at 18 km / h 18 dB-A
- Length: 140 mm
Gooseneck for CCM microphonesThis gooseneck has a plug for CCM-L compact microphones at the top....
Gooseneck for CCM microphonesThis gooseneck has a plug for CCM-L compact microphones at the top. Its upper and middle parts are flexible, while the lower part (120mm) is designed as a tube to ensure sufficient stability despite the small diameter....
- 5m Connection cable to XLR
- Especially long gooseneck
- Length: 420mm
Stand Joint For active tubes (8mm) and stand tubes (12mm), Angle degree can be changed, Colour: Grey (matt)
- For active tubes (8mm) and stand tubes (12mm)
- Angle degree can be changed
- Colour: Grey (matt)
PopscreenIt is sufficient for medium-to-high speakers to protect the cardioid and other pressure gradient receivers, especially when they are speech microphones. For bullets it is sufficient even in low winds. Very low sound. Dimensions: 70 mm ×...
- Dimensions: 70 mm × Ø 45 mm (max)
- Colour: grey (standard)
Small close-speech guard Made of washable nylon fabric, Wind noise attenuation at 18 km/h with bullet microphones: 25 dB-A, With supercardioid microphones: 26 dB-A, Diameter 50 mm, Colour: Grey, Not suitable for the following types: MK 4V, MK 41V,...
- Made of washable nylon fabric
- Wind noise attenuation at 18 km/h with bullet microphones: 25 dB-A
- With supercardioid microphones: 26 dB-A
Elastic suspension holder For MS stereo method, For 20 mm microphones (CMC with capsule)
- For MS stereo method
- For 20 mm microphones (CMC with capsule)
Stand Tube These stand tubes have a 3/8" threaded pin at the top and a 3/8" female thread at the bottom. Therefore, several rods can be screwed together. They also fit into the collets of the bottom leg BF...
- Suitable for BF 250 sockets
- Length: 350 mm
Flute adapter Allows the use of a CCM compact microphone on the flute, The FA 1 is a plastic double clip that simply clips onto the mouth end of the flute, The 0° axis of the microphone capsule should...
- Allows the use of a CCM compact microphone on the flute
- The FA 1 is a plastic double clip that simply clips onto the mouth end of the flute
- The 0° axis of the microphone capsule should point to the mouth hole
Microphone Stand With swivel joint, Suitable for CCM-L compact microphones, Height-adjustable, 360 ° rotatable, Length: 900 - 1400 mm, Diameter: 22/18 mm, 3-pin. XLR output, Colour: Matte-grey, Optional base BF 250 is recommended
- With swivel joint
- Suitable for CCM-L compact microphones
Stand Clamp With joint, With metal clamp, For compact microphones
- With joint
- With metal clamp
- For compact microphones
Microphone amplifierThe microphone amplifiers CMC are not (power) amplifiers in the usual sense. Its task is to adapt the signals of the high-impedance capacitor capsule for the very low-impedance, balanced transmission through the microphone cable. The different versions differ by...
- Power supply for 48 V phantom for capsules of the MK series
- Current consumption: 4 mA
- Length: 113 mm
Stand clamp With joint, With clamp made of grey plastic, For compact microphones
- With joint
- With clamp made of grey plastic
- For compact microphones
Stand Connection Joint
Stand Connection Joint For connecting two STR stand bars
- For connecting two STR stand bars
Gooseneck For Schoeps MK capsules for table installation with 120 mm fixed tube, Length: 420mm, Color: Dull grey
- For Schoeps MK capsules for table installation with 120 mm fixed tube
- Length: 420mm
- Color: Dull grey
Heavy Base PlateThe BF 250 is supplied complete with the SPV 12-3 / 8 collets for 12 mm diameter stand rods. The tripod rods are fixed by hand with a short rotation of the knurled override. The SPV 12-3 /...
- Including Collets for 12 mm pipes
- Diameter: 250 mm
- Height (without SPV): 38 mm
Double clamp To upgrade from mono to MS stereo microphone
- To upgrade from mono to MS stereo microphone
Offers include 21% Belgium VAT and are valid as long as stocks last. Shipping costs to Belgium are 2,50 EUR, free shipping on orders above 49 EUR. Please click here for international Shipping rates. We do not accept liability for typographical errors or inaccurate information of any kind. *RRP = manufacturer's / distributor's recommended retail price in Germany