Doepfer A-100 PMS 9 PSU3

5

Empty Housing for Eurorack Modules

  • 168 HP / 9 U
  • 100 - 240 V
  • 2 Built-in A-100PSU3: +12 V / 4000 mA, -12 V / 2400 mA, +5 V / 8000 mA
  • 6 Doepfer A-100 V6 Bus Boards with slots for up to 132 modules
  • Usable depth for modules: 70 mm in the area of the power supply unit, otherwise 100 mm
  • External dimensions with lid (W x H x D): approx. 90 x 48 x 23 cm (18 cm without lid)
  • Weight incl. lid: approx. 14 kg
Myynnissä vuodesta Helmikuu 2021
Tuotenumero 508781
Myyntierä 1 kappaletta
System Eurorack
Width 3x 168 TE / HP
Height 9 U
Power Supply Yes
Formfactor Case
Power Supply Specifications +12V/4000 mA, -12V/2400mA, +5V/8000mA
1 290 €
Kaikki hinnat sis. ALV:n
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
llmainen toimitus. Arvioitu toimituspäivä Maanantai, 6.05. ja Tiistai, 7.05. välillä.
1

5 Asiakkaiden arviot

4 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Ominaisuudet

Työnjälki

4 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
G
Mostly great, potentially a bit power starved
Geoffp 23.03.2022
I bought this to house diy NLC modules, which are mercifully low on their power requirements. It’s worth noting that this has the lowest power rating / hp of all Doepfer monsters (go one up and you get two psus for four rows, go one down and you get one psu for two rows). It’s utterly fine for low current modules, but do plan it out if going more mainstream.

I also bought this to go on top of a 12u monster. It works, it is stable, but it’s also worth noting that the connecting hinges needed to be drilled out to connect the cases together. They are not a clean fit.

The case itself is great! Deep, spacious, sensible rails. I don’t need the portability, but some of the additional costs over eg an ADDAC whopper is in the flight case design. It’s great as a flat against the wall case, and totally does it’s job.

Not deep enough to hold a spring reverb tank flat / horizontal. Pretty much the only fitting challenge I’ve hit!
Ominaisuudet
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta