La conținutul paginii

Machine Head Set for Electric Bass

  • F-Style
  • Style: 4 Left
  • Bore: 18.5 mm
  • Gear ratio: 1:22
  • Surface: Nickel

Hole spacing on the base plate:

  • Narrow side: 20 mm
  • Wide side: 26 mm
  • From top to bottom: 34.4 mm

Dimensions of base plate:

  • Length: 45.3 mm
  • Width 1: 33.35 mm
  • Width 2: 27.2 mm
  • disponibil din Decembrie 2019
  • numărul articolului 480068
  • unitate de vânzare 1 bucată(ăţi)
  • Colour Nickel
229 lei
Toate prețurile includ TVA
în stoc
1

39 Evaluările clienților

4.8 / 5

Măiestrie

31 Recenzii

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
M
Put them on an old neck. Great tuners!
Muziekschuur 10.12.2020
The good stuff! Nuff said. Thomann sells them. Get some.
Tune up and rock out.
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
J
Good budget replacements
Jezzaboy 18.04.2020
Cheap tuners are part of the reason some basses are lower price. You cannot spend £300 and expect USA quality. Usually I would buy a set of Schaller tuners as they are my favourites but they are about £70-£80 delivered.

I recently picked up a cheap Squier and thought I would try the Kluson tuners to keep the cost down. They are quite good and keep the vintage look I was looking for. I still prefer my Schaller`s but for a budget bass, these do the trick fine.
Măiestrie
3
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
M
Tuners ok, screws are very bad
MicDecorte 18.02.2026
The tuner mechanisms appear to be of good quality.

However, the screws are of very poor quality. If you want to buy these tuning mechanisms, you should also buy different screws. Three of the screw heads broke off when I used them. I had pre-drilled the holes. Two screws broke off before I could tighten them. One screw broke off while I was tightening it.

I am going to replace the screws because I don't trust that they will stay tight in the future.
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
c
Tuners are OK but screws way to fragile
clowl 02.07.2025
I bought these tuners for an original Fender MiM neck. When mounting the tuners half the screws broke (head broke off) before it was fully tightened. Gave me a lot of extra work drilling out the metal and fitting new screws.
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz