Harley Benton SC-450 P90 GT Classic Series

I bought this because I had severe GAS on p90 guitars. I first opted for the SC special one, but I just don't dig the mustard colour. This one is also way cheaper so it's was an easy choice!

It arrived within 3 days after ordering on sunday. Awesome!

The guitar looked great but out of the box there were some small issues. The setup was not great (although not bad) and there are a few little finish flaws. But hey, for this money you can't expect perfection.

Tuners are ok, not going to swap them because they hold tune just fine. They also turn smooth, the throw is a bit short, so when tuning just be really careful.

The nut is cut fine, it's plastic but I don't care. I put some pencil graphite in there and it's now smooth as any nut. EDIT: the nut was causing major tuning issues. Installed a graphtech nut and it holds tune very well. The tuners are really good enough.

Fretboard looks nice, was very dry an needed some oil.
The frets were a bit rough, needed some polishing with 0000 steel wool. Be sure to mask the pickups with tape when using steel wool!

There are a few high frets here and there. Nothing really disturbing. I've set the action on 2mm low e and 1.5mm high e. It buzzes a little, but can't hear it when playing on the amp. I do however want to try a fret level on this one to see how this goes. A guitar this cheap is a nice practise object. EDIT: I leveled the frets. It was my first attempt and I improved the playability. Still 2 or 3 frets that are a little higher. I might spot level them with the next string change.
EDIT: I don't know if the wood in the neck still thinks it's alive. I've done a second full fret leveling as 13 frets were again uneven. It's now completely level and plays great. Hope it stays this way, because I'm not doing a third leveling ;).

The pickups sound ok but not for me. They are ceramic of course and I don't like the boomy attacky sound of ceramic magnets. I ordered some alnico IV magnets to put in these p90's to see if they can sound the way I like them to sound. EDIT: the alnico IV magnets are installed. It didn't really change the tone much. I might go for some vintage voiced alnico 2 pickups. EDIT: A new set of p90's are on the way. A combo of A2 neck + A5 bridge with low output.

The pots are the cheap mini pots and they put linear pots in for the volume control. I like log pots better so I will swap them at one point. They do work fine though and they are not scratchy. I think I will buy Alpha pots, because CTS pots have too wide bushings. You need to ream out the holes and I'm not going to bother doing this :). EDIT: Yeah so I've grown to love linear volume pots... So much better volume control! Really the whole range from 10 to 1 is usable now, instead of most action happening from 10 to 7 on log pots.

The switch is cheap, but works fine, no need to replace.

Oh yeah one nice tip: when ordering I placed a remark asking if they could select a lighter weighing one for me. And they did! Mine weighs about 3.8kg (8.4 lbs) which is pretty lightweight for a Les Paul style!

Because the colour is more copper than gold, I also ordered black plastics for the pickups, switch and knobs. Looks awesome!

All in all I'm happy with the guitar. It's a love/hate relationship with this one. By far the worst HB guitar I've had, but I learned to level frets on this guitar and I dig p90's. I might sell it on later, but will definitely need a p90 guitar in my arsenal.

I've been playing for 47 years now as both a semi-pro and amateur/hobbyist, and a lot of great instruments have passed though my hands over the years. This is one of them. If you have some basic knowledge of how to properly setup, care for, and modify guitars there is no reason you couldn't have a Les Paul every bit as good as the real thing. For me, the only modifications I've made was to 1) swap out the tuners as they had a tendency to not immediately catch or engage at times, and 2) put on an Earvana Compensating Nut (which I automatically do to ALL my guitars). There was nothing wrong with the intonation and, in fact, the intonation was perfectly setup right out of the box! However, I mostly play around the first 4 frets where intonation is problematic on ANY guitar (even $20,000 ones!) and the Earvana solves that problem. Regardless of the "catching" problem, the tuners did work and the guitar had no problems staying in tune. I choose to replace the tuners with the Wilkinson EZ-LOK tuners which retail for about $20 USD and work great, so it hasn't proven to be a deal-breaker.

The fit and finish are simply flawless! This is a beautiful looking instrument. My "gold" top is actually a little more on the copper side (too much red pigment?), but I've come to really like it this way. It still looks fantastic and it makes mine unique (I hope)!

As far as the neck and frets go: I see no issues whatsoever with the neck or frets. Frets are smooth and polished with no sharp ends. The neck feels and plays simply great. for those concerned about neck-dive, this model is well-balanced and there is no neck-dive with it. One thing I especially like about the neck is that the headstock is at a 14° angle like the Epiphones and not 17° like the Gibsons. This means there's less (unnecessary) tension on the neck/headstock so that the neck is more resistant to breaking while still providing all the tension you need. Why Gibson continues to use a 17° is beyond me as it's completely unnecessary and only weakens the neck. The SC-450 also has a scarf joint which aids GREATLY in preventing neck breakage. Yes, I like scarf joints and you should too. Nice touch, Thomann!

The inlays are perfect and centered. The bindings are perfect with no gaps or marring.

The weight is pretty hefty although not as heavy as an actual Les Paul.

The electronics, knobs, and switches are all solid and there are no problems there. The P90 pickups, which is WHY I got this particular gold top model are simply luscious! Nice beefy sound with a nice tonal range. Everything you'd want in a classic P90. If you know P90s you either love them or hate them. I love P90s and the Roswells are outstanding. Yes, they're a bit noisy, but that's all P90s (which is why some people hate them). You learn to deal with the hum because nothing else sounds like a P90. This thing grinds/rocks like a champion!

The bridge and tailpiece are solid and I see no problems there.

This guitar just smacks of amazingly good quality and craftsmanship and it astounds me as to how Thomann can do this for so little money! This is my first experience with an Harley Benton Les Paul and based on this I will be buying more HB Les Pauls. Right now I'm looking at that beautiful white one!

The guitar arrived in good shape. The finish and colour are amazing for this price tag (and my taste) but other than that, there are a few things that need to be "fixed".

Neck is straight and fat which is a bit odd (been used to faster necks) but will eventually get used to it.
The fretboard was dead dry so needed some oil treatment but the blackwood looks pretty cool.
Frets needed polishing since bending the strings is obviously not even close to smooth. They also need levelling in the B and high E strings at 17-19 where there are a few dead spots. Also some buzzing which needs to be reviewed/adjusted I guess.
The guitar is pretty heavy which can be either a good or a bad thing and a matter of personal taste.
Tuners are just OK.
Intonation was interestingly pretty on spot (nice one there).
Pots and switch look really cheap but work OK for now.
Nut has not been cut/finished with care (has remnants of the actual cut and not been sanded at all).

Overall at 166 euros, I don't think you can get something better (not even used) so if you have the knowledge and time to spare to get it properly playing, go for it. If not, you may end up with a guitar that is difficult to play. It's a good basis for experimentation on updates/maintenance and in general, stuff you wouldn't do in more expensive guitars but can also be a great (and stunning) player if you treat her well.