Den stora Thomann Online-Rådgivaren: Synthesizers

3. Subtractive Synthesis

In its simplest form, three main sections are incorporated - an oscillator, filter and amplifier. The oscillator generates the basic sound, usually a sine, pulse or sawtooth wave; the filter contours the frequency spectrum of the wave from the oscillator; and the amplifier controls the volume of the generated and filtered waveform over time -– its ‘envelope’. Note that the horizontal lines in the diagram below indicate the path of the sound itself - the vertical lines indicate control signals. The envelope for example only modulates (controls) the amplifier – it does not affect the sound directly.

We’ll now look at each section in turn, starting with the oscillators, as this is where the sound originates. As they produce the basic building block of the sound, some method is necessary to control their pitch from a keyboard. In the analogue world, this is done by means of control voltages (hence the label Voltage Controlled Oscillator or ‘VCO’), and the most common approach was the so-called 'one volt per octave' system. The keyboard is arranged so that whenever a key is depressed, an electrical voltage is produced, which in effect is used to tune the oscillator to the required note.

The raw oscillator sound can usually take the form of one of a number of different waveshapes, to allow you to choose from a range of basic timbres appropriate to the sound you might want to achieve. Each waveform has its own characteristic spectrum by which it can be identified:

Sawtooth

Sawtooth - sometimes known simply as ‘Saw’, it contains all harmonics, odd and even, in proportional values, and because of this, it sounds ‘rich’ and ‘buzzy’. The high harmonics have a relatively large amplitude which gives the waveform its characteristically ‘bright’ sound.

Pulse

The Pulse wave is a rectangular waveform, usually with the ability to have the ratio of the length of its positive cycle to its negative cycle (or its ‘width’) varied by an LFO (see below). Where the width is at its narrowest, it sounds thin and nasal, and this is sometimes called the ‘duty cycle’. Where the width is equal on each cycle, it is also known as a square wave:

Square

A special type of pulse wave because it contains only odd (and no even) harmonics or ‘partials’, and as a result has a hollow sound, not entirely dissimilar to a clarinet. The harmonics decrease in amplitude with frequency.

Sine

A sine wave contains only the ‘base’ or ‘fundamental’ frequency, and no harmonics, which is why it sounds ‘pure’ or ‘simple’. It is difficult to do much to change the sound of a sine wave!

Noise

Noise - or more precisely ‘white’ noise, which is the type most commonly found on synthesizers, contains all frequencies continuously randomly changing. It has no harmonics or partials, since the frequencies are not even multiples of each other. It also has no base frequency or fundamental. ‘Pink’ noise has less high frequency content than white noise, while ‘brown’ noise has less still.

Sync

Most multi-oscillator synths feature a ‘sync’ function, usually on the second oscillator. This forces the oscillator being modulated (usually the first) to restart its waveform from zero every time the modulating oscillator completes one cycle. As a result, when you change the frequency of the modulated oscillator, rather than changing the pitch, it changes the timbre, producing a characteristic metallic sound.

Filter

The filter is generally considered to be the most important part of any synthesizer, almost regardless of the type of synthesis used, as it is the parameter that affects the sound most drastically. Filters come in many different forms - the most common classification method is based on the shape of the attenuation curve. If a sine wave of a given frequency is fed through a filter, then the output represents the attenuation of the filter at that frequency. When measured at multiple frequencies and plotted on a graph, this is called the frequency response curve of the filter. The most common types of filter curves are low-pass (cuts high frequencies and lets low frequencies pass – the most common of all); high-pass (cuts low frequencies and lets high frequencies pass); band-pass (cuts high and low frequencies and lets the mid pass); and notch (cuts a very narrow band of frequencies).

The point at which the filter begins to affect the signal is called the cut-off point, and this is usually the filter’s main control on a synthesizer. The steepness of the cut-off slope also has a strong effect on the sound - most current analogue synths (or ‘models’ thereof) have 12 or 24dB/octave filters, which is achieved by cascading a number of simpler 6dB filters together to produce a steeper slope. Each of these filters is also known as a ‘pole’ - a 24dB/octave filter is often called a ‘4 pole’ filter.

The last important aspect of a filter is its ‘resonance’ control – increasing resonance emphasises a very narrow band of frequencies around the cut-off point, and creates the ‘wow’ sound that is characteristic of a subtractive synthesizer. At extreme settings, some filters go into ‘self oscillation’, which produces a distinct sine wave-like tone around the cutoff frequency.

Envelope

Envelope - the term used to describe the shape of the volume of a sound over time. Most synthesizers provide an ‘envelope generator’ which modulates the amplifier to control the envelope – its parameters are commonly split into segments called Attack, Decay, Sustain and Release. The time from silence to the initial loudest point is the ‘Attack’, while the time for the envelope to decrease after this to a steady value is the ‘Decay’. The sound then continues at a level known as ‘Sustain’, and remains at this level as long as the key is held down. Once the key is released, the sound resumes its decay, this time at a rate determined by the ‘Release’ setting. It is important to note that while Attack, Decay and Release control the rate at which the envelope settings change, the Sustain parameter is a level. Once the idea of envelope generators had been thought of, it was realised that they could also be used to modulate other aspects of synthesis such as filter cutoff, and so most subtractive synthesizers offer at least two.

LFO – Low Frequency Oscillator

LFO – a ‘Low Frequency Oscillator’, used not to produce sound (its frequency range would be too low to hear!), but like envelope generators, as a control signal. The most common use is to modulate the pitch of an oscillator to produce a vibrato effect, but it can also be used to modulate the amplifier for tremolo, or the filter, for instance synchronised to MIDI clock to produce long filter sweeps in time with the music. Like regular oscillators, LFOs can have many different wave shapes.

Din kontaktperson
Tel +49-9546-9223-30
Fax +49-9546-922328
Hot Deals Beställ en gratis Hot Deal!

Över 9.000.000 musiker prenumererar redan på Thomann Hot Deals. Börja prenumerera gratis och få tillgång till mer än 400 aktuella erbjudanden!

Synthesizers översikt

Alesis Surge Mesh Kit Adam T5V Subpac M2X Roland R-07 black Yamaha Stagepas 600BT Arturia Minibrute 2 Focal Listen Professional Heritage Audio HA-73 EQ Elite Epiphone Richie Faulkner Flying V Focal Shape Twin Sound Devices MixPre-3 Yamaha Stagepas 400BT
Rekommenderat
Alesis Surge Mesh Kit

E-Drum Set 385 Sounds, 40 kits, 60 songs, Additional input for a fourth tom and a second crash pad, 2 Master outputs 6.3 mm mono jack, Headphone output 3.5 mm stereo jack, Aux input 3.5mm stereo jack, MIDI input...

Till produkter
609 €
(1)
Rekommenderat
Adam T5V

Active Nearfield Monitor Equipped with: 5" woofer and 1.9" U-ART ribbon tweeter, 2x Class-D amplifiers: 50W RMS woofer, 20W RMS tweeter, Frequency range: 45 - 25000 Hz, Crossover frequency: 3 kHz, Maximum input level: 106 dB (1m/pair), Rear bass...

Till produkter
169 €
Rekommenderat
Subpac M2X

Subpac M2X, Mobile tactile bass system, SubPac adds real depth, connection and enjoyment to whatever you play through it - your music and media comes to life with the added dimension of physical bass. Frequency Response: 1hz-200hz, Wired Input: 3.5mm...

Till produkter
399 €
(1)
Rekommenderat
Roland R-07 black

Portable MP3 / WAV Recorder with Bluetooth Functionality Stereo recordings up to 24 Bit / 96 kHz in WAV format or up to 396 kbps in MP3 format on microSD / SDHC card, Built-in stereo microphone, Integrated hybrid limiter,...

Till produkter
229 €
Rekommenderat
Yamaha Stagepas 600BT

Mini-PA System with Bluetooth Function Consisting of 2x passive 2-way boxes and 10-channel power mixers, Power mixers and speaker cables can be stored in the boxes for transportation, Successor of the Stagepas 600i, Including 2 speaker cables, each 6...

Till produkter
798 €
(2)
Rekommenderat
Arturia Minibrute 2

Arturia Minibrute 2; analog semi-modular Synthesizer; Combination of classic and modular Synthesizer; 25 note Keyboard with Aftertouch; Brute-Oscillator; Steiner-Parker-Filter; additional Loop-Envelope; linear FM; Hardsync; two free assignable LFOs; integrated Step Sequencer; Arpeggiator; 48 point Patchbay; Pitch- and Modulation Wheel; Connections:...

Till produkter
666 €
Rekommenderat
Focal Listen Professional

Headphones Closed, Circumaural, Conversion technology for acoustic transparency and dynamics, Impedance: 32 ohms, Sensitivity (@ 1 kHz - / 1 Vrms): 122 dB SPL, THD (THD, @ 1 kHz / 100 dB SPL): 0.3%, Frequency range: 5 Hz to...

Till produkter
248 €
Rekommenderat
Heritage Audio HA-73 EQ Elite

Heritage Audio HA-73 EQ Elite; 1-Channel Mic-Preamp wit EQ; based on the 1073; hand wound Carnhill Transformers; 3 stage fully discrete class A mic preamp; max. Gain: 80 dB Mic and 50 dB Line; -20 dB Pad; LO-Z switches the...

Till produkter
945 €
(1)
Rekommenderat
Epiphone Richie Faulkner Flying V

Electric Guitar Body and neck: Mahogany, Fretboard: Ebony, Neck profile: Thin C, 22 Jumbo frets, Scale: 628 mm, Pickups: Active EMG 57 (bridge) and EMG 66 (neck) humbucker, Floyd Rose 1000, Grover Rotomatic machine heads, Colour: Black, Incl. Deluxe...

Till produkter
935 €
(1)
Rekommenderat
Focal Shape Twin

Active Near Field Monitor Tweeter with low directivity for flexible listening position, Closed design with two passive membranes for easy installation near the wall, 2.5-Way concept for optimal control of the bass and lower mids, Optimal integration through extensive...

Till produkter
845 €
Rekommenderat
Sound Devices MixPre-3

Sound Devices MixPre-3; portable audio recorder with USB audio interface; 5 tracks: stereo mix + 3 isolated tracks; Kashmir microphone preamp with 76db gain; equivalent Input Noise: 128dBu max (A-weighting, gain=76dB, 150 Ohm source impedance); limiter per channel; low cut...

Till produkter
775 €
Rekommenderat
Yamaha Stagepas 400BT

Mini-PA System Bluetooth Function Consisting of 2x passive 2-way boxes and 8-channel power mixers, Power mixers and speaker cables can be stored in the boxes for transportation, Successor of the Stagepas 400i, Including 2 speaker cables, each 6 m...

Till produkter
555 €
Feedback Har du hittat ett fel eller vill ge oss feedback om denna sida?

Vi ser fram emot att höra från dig och kommer att lösa eventuella problem så snart vi kan.

Lämna kommentar. Ange din e-postadress.