• Önskelista
  • Välj din butik Select Store
    Alla länder All Countries
  • 0

Den stora Thomann Online-Rådgivaren: Flutes

5. The Mechanism

The mechanism or ‘keywork’ of the flute is found on the body and footjoint - the keys are depressed with the player’s fingers onto the ‘tone-holes’ of the flute in order to change the pitch that is produced.

Unlike the tone-holes of wooden instruments, which are normally carved into the body of the instrument, the tone-holes of the modern flute are either extruded or ‘drawn’ from the body of the tube, or soldered directly onto the tube. In both cases, the tone-holes protrude from the tube by around 5mm at their highest and 1mm at their lowest.

Drawn tone-holes are made by a machine which extrudes them from the tube of the instrument through the use of heat and spinning ball-bearings, and then rolls the top of them down until they are flat and even.

Soldered tone-holes are soldered to the tube by hand, which is a labour intensive and time consuming job. Drawn tone-holes are therefore usually found on most student and mid-range instruments, and it is generally only handmade instruments played by professionals that are made with soldered tone-holes.

Din kontaktperson
Tel +49-9546-9223-26
Fax +49-9546-9223-24
Beställ en gratis Hot Deal!

Över 7.900.000 musiker prenumererar redan på Thomann Hot Deals. Börja prenumerera gratis och få tillgång till mer än 500 aktuella erbjudanden!

Hot Deals
ett Thomann-fan
Diese Seite ist der Hammer! Hier findet man alles, was man braucht.
okänd, 17.04.2015

Flutes översikt

(2)
(1)
(12)
Feedback

Har du hittat ett fel eller vill ge oss feedback om denna sida?

Vi ser fram emot att höra från dig och kommer att lösa eventuella problem så snart vi kan.

avbryt