Thomann V2020 Black 10 Pack

7573

Velcro Cable Ties, Pack of 10

  • With Velcro
  • Size (W x L): 20 x 200 mm
  • Pack of 10
  • Ideal for microphone and speaker cables up to 10 m long
  • Colour: Black
numărul articolului 105250
unitate de vânzare 1 bucată(ăţi)
Type Hook&Loop cable tie
Colour Black
Length [cm] 20 cm
Width [cm] 2 cm
Reusable Yes
Flame Retardant No
6,90 € 34,10 lei
Include TVA la care se adaugă 19,90 € costul de transport
Prețul în lei este doar de ghidaj!
Reduceri pe volum
Preț pe bucată Veți economisi Cantitate
6,90 € 1
6,29 € 8,8% 4
5,69 € 17,5% 10
în stoc
în stoc

Acest articol este disponibil în stoc și se poate expedia imediat.

Informații despre livrare
Livrare aprox. între Joi, 2.06. și Vineri, 3.06.
1
DG
DJ Gabriel MP 27.08.2019
Foarte bune, nu se rup usor !
Ajuta foarte bine la organizarea cablurilor.
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

M
Nu mai îmi stă cablurile în toate felurile
MKároly 28.04.2022
Pot să îmi aranjez cablurile strânse foarte ușor și nu se mai încurcă între ele
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

c
Foarte practice
cata_magnat 30.08.2019
Produs de 5 stele,
Felicitati si echipe Thomann pentru profesionalism in preluarea/procesarea comenzilor
Măiestrie
0
0
semnaleaza un abuz

semnaleaza un abuz

google translate gb
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
R
Really good cable ties
Rob_B 01.12.2019
I've been using these for a couple of years now, for holding wound-up cables together, as well as holding XLR cables to mic boompoles. And very good they are, too.

Another reviewer here had noticed that the cable-tie often slipped off the end after the cable had been unwound, and that is what I had always noticed. UNTIL, that is, I recently noticed the little graphic "Cable Tie. How to use?"

At first, this graphic did not make much sense to me, until I realised that it represented how to attach the cable-tie to ONE END of the unwound cable only, so that it always stays fixed to that end of the cable, and a long tail of the cable tie is then available for holding the rest of the cable after it has been wound up.

This was a revelation to me, and has made the job of managing the cables and their cable ties much easier. So, attaching the cable-tie near to the cable end for the first time is a really fiddly job, but once it's attached, it can be pulled tight enough that it stays there, and leaves the rest of the cable-tie ready for use when the cable is wound up again.

If I have one gripe about the cable-tie, it's that the very end of the tie should ideally have a couple of millimeters free of velcro hooks, to make it easier to lift that end when it's time to uncoil the cable. I usually subject the hooks at the very end of each cable to a short burst of heat from a soldering iron set to very low heat to achieve this.
Măiestrie
1
0
semnaleaza un abuz

semnaleaza un abuz