TritonAudio FetHead Phantom

88

Microphone Preamp

  • For condenser microphones
  • Extremely low-noise Class A JFet amplifier
  • XLR 3-pin female to XLR 3-pin male
  • 18 dB gain (@3 kOhm load)
  • 4 Coordinated JFets
  • 48 V Phantom power
  • Transfers phantom power to the microphone
Disponível desde Maio 2018
número de artigo 439148
unidade de venda 1 peça(s)
Channels 1
Number of microphone inputs 1
Instrument input No
Tubes No
Compressor/Limiter No
Equalizer No
De-Esser No
Phantom power No
Phase Reverse No
External effect loops No
Analogue Outputs XLR
Digitale Outputs 0
Headphone connection No
Level Meter No
Design Adaptor
€ 75
IVA incluído, € 20 de portes de envio adicionais
Em stock
Em stock

Este artigo encontra-se em stock e pode ser enviado imediatemente.

Informações sobre o envio
Entrega entre aprox. Quinta, 30.06. e Sexta, 1.07.
1

88 Avaliações de clientes

56 Críticas

K
Notei diferença!
Karussa 01.04.2022
Ouvi falar muito deste preamp e sem duvida agradou-me muito, notei muita diferença para melhor.
manuseio
características
som
acabamento
0
0
Reportar a crítica

Reportar a crítica

google translate gb
Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
z
Perfect for my needs
zorglub76 08.03.2021
First of all, I don't have a producer's ears. So when I say that there's absolutely no noise when using these preamps, take it with a grain of salt.
I have a specific problem that I tried to solve with the FetHead, and I solved it easily. The problem is that I'm getting some digital noise in my Focusrite Scarlett whenever I turn gain passed 1 o'clock. I don't know if it's a psu, or the nearby laptop or something else, but I couldn't get rid of it.
Now, with the FetHeads, I pre-amplify my mic, and I need just a slight gain from Scarlett, so the noise is gone! The sound is exactly the same as without the FetHead, just louder. I hear no distortion or noise. I'm using Lewitt small diaphragm mics that are especially noiseless, but I hope the others would behave the same.
I'd recommend FetHead as a cheap solution to any gain related problems you might have.
manuseio
características
som
acabamento
2
0
Reportar a crítica

Reportar a crítica

google translate gb
Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
M
Amazing
MB202 18.12.2020
For this price you get a a lot of extra gain with no loss of audio quality (somehow, I get only 15Db, but OK). Very useful to pump up any signal. More importantly, it makes your mics sound better as you don't have to crank up the pre (better to find that the "sweet spot"). Highly commendable.
manuseio
características
som
acabamento
1
0
Reportar a crítica

Reportar a crítica

google translate gb
Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
R
Serves the required purpose for relatively low gain condenser microphone.
Robert8105 19.03.2019
I have a particular condenser microphone that needs a high gain setting on my mixer's preamp, and so has a tendency to cause noise because of the near maximum setting. The FetHead Phantom was the answer because this in-line microphone booster takes its power from the phantom power supplied by the mixer at source and in so doing the FetHead's energised circuits enable about + 18dB further gain to be inserted at the right point. The whole purpose of the device is then achieved because it means the mixer gain rotary switch was advanced to a lesser point than without the FetHead and so noise was eliminated.
The Triton FetHead was cheaper than some rivals and effective for my purposes although no comparisons were made with other makes.
manuseio
características
som
acabamento
4
0
Reportar a crítica

Reportar a crítica

YouTube sobre este assunto