Schoeps Acessórios para microfones
30 Acertos. Visualizando artigos 1–25.
Todos os preços incl. IVA Frete grátis a partir de € 199
Microphone Amplifier CMC for MK Series CapsulesThe microphone amplifiers CMC are not amplifiers in the classical sense. Their task is rather to adapt the signals of the high-impedance condensate capsule for the very low-impedance, balanced transmission through the microphone cable....
- Power supply for capsules of MK series
- Power supply by 12V - 48V phantom power
- With balanced, especially low-impedance output
Hollow Foam Popscreen B 5 D For use especially on pressure-gradient transducers in light wind and as a close-speech guard. The B 5 D offers good effectiveness, yet has only a slight influence on the sound. It is made...
- Dimensions: 70 × Ø 50 mm (max)
- Colour: Grey
- Additional gray flocking
Microphone Outdoor Protection Consisting of wind shield R1 and W 20 R Wind protection basket W 20 R, Wind noise attenuation at 18 km / h with balls 43 dB-A, with a supercardioid 51 dB-A, Diameter: 90 mm, Colour:...
- Consisting of wind shield R1 and W 20 R Wind protection basket W 20 R
- Wind noise attenuation at 18 km / h with balls 43 dB-A, with a supercardioid 51 dB-A
- Diameter: 90 mm
Stand ClipThis tripod clip with joint has a foot with a 5/8 "-27 NS internal thread. Thanks to the supplied adapter, it can be screwed onto any type of tripod with 3/8" or 1/2" etc. The inclination of the microphone...
- With joint
- For microphones with a diameter of 20 mm
Microphone AmplifierThe CMC 6 xt is a special version of the phantom-powered microphone amplifier...
Microphone AmplifierThe CMC 6 xt is a special version of the phantom-powered microphone amplifier CMC 6. Connecting one of many microphone MK capsules of the SCHOEPS module system into the amplifier creates a complete microphone. It can operate...
- With extended frequency response up to 40 kHz
- For capsules from the MK series
- Powered by 12V - 48V phantom power
Active Extension Tube
Active Extension Tube Length: 1200 mm, Colour: Anthracite, Tube swivel RG 8 included
- Length: 1200 mm
- Colour: Anthracite
- Tube swivel RG 8 included
Windscreen Made of nylon fabric for the CMC series, Two separable halves, Wind noise attenuation at 18 km/h with omni-directional microphones 29 dB-A, Wind noise attenuation at 18 km/h with super-cardioid capsule 38 dB-A, Diameter: 80 mm, Colour: Light...
- Made of nylon fabric for the CMC series
- Two separable halves
- Wind noise attenuation at 18 km/h with omni-directional microphones 29 dB-A
WindshieldHighly effective wind shield for pressure gradient and pressure receivers with low sound effects. The foam hollow sphere encloses an air volume around the capsule, similar to a wind protection basket. Particularly when using CCM-L, care must be taken that...
- Dimensions: ball with Ø 90 mm
- Colour: Black
- Additional black flocking
Gooseneck for CCM microphonesThis gooseneck has a plug for CCM-L compact microphones at the top....
Gooseneck for CCM microphonesThis gooseneck has a plug for CCM-L compact microphones at the top. Its upper and middle parts are flexible, while the lower part (120mm) is designed as a tube to ensure sufficient stability despite the small diameter....
- 5m Connection cable to XLR
- Especially long gooseneck
- Length: 420mm
Stand Joint For active tubes (8mm) and stand tubes (12mm), Angle degree can be changed, Colour: Grey (matt)
- For active tubes (8mm) and stand tubes (12mm)
- Angle degree can be changed
- Colour: Grey (matt)
PopscreenIt is sufficient for medium-to-high speakers to protect the cardioid and other pressure gradient receivers, especially when they are speech microphones. For bullets it is sufficient even in low winds. Very low sound. Dimensions: 70 mm ×...
- Dimensions: 70 mm × Ø 45 mm (max)
- Colour: grey (standard)
Small close-speech guard Made of washable nylon fabric, Wind noise attenuation at 18 km/h with bullet microphones: 25 dB-A, With supercardioid microphones: 26 dB-A, Diameter 50 mm, Colour: Grey, Not suitable for the following types: MK 4V, MK 41V,...
- Made of washable nylon fabric
- Wind noise attenuation at 18 km/h with bullet microphones: 25 dB-A
- With supercardioid microphones: 26 dB-A
Elastic suspension holder For MS stereo method, For 20 mm microphones (CMC with capsule)
- For MS stereo method
- For 20 mm microphones (CMC with capsule)
Stand Tube These stand tubes have a 3/8" threaded pin at the top and a 3/8" female thread at the bottom. Therefore, several rods can be screwed together. They also fit into the collets of the bottom leg BF...
- Suitable for BF 250 sockets
- Length: 350 mm
Flute adapter Allows the use of a CCM compact microphone on the flute, The FA 1 is a plastic double clip that simply clips onto the mouth end of the flute, The 0° axis of the microphone capsule should...
- Allows the use of a CCM compact microphone on the flute
- The FA 1 is a plastic double clip that simply clips onto the mouth end of the flute
- The 0° axis of the microphone capsule should point to the mouth hole
Stand Clamp With joint, With metal clamp, For compact microphones
- With joint
- With metal clamp
- For compact microphones
Microphone amplifierThe microphone amplifiers CMC are not (power) amplifiers in the usual sense. Its task is to adapt the signals of the high-impedance capacitor capsule for the very low-impedance, balanced transmission through the microphone cable. The different versions differ by...
- Power supply for 48 V phantom for capsules of the MK series
- Current consumption: 4 mA
- Length: 113 mm
Stand Connection Joint
Stand Connection Joint For connecting two STR stand bars
- For connecting two STR stand bars
Stand clamp With joint, With clamp made of grey plastic, For compact microphones
- With joint
- With clamp made of grey plastic
- For compact microphones
Gooseneck For Schoeps MK capsules for table installation with 120 mm fixed tube, Length: 420mm, Color: Dull grey
- For Schoeps MK capsules for table installation with 120 mm fixed tube
- Length: 420mm
- Color: Dull grey
Heavy Base PlateThe BF 250 is supplied complete with the SPV 12-3 / 8 collets for 12 mm diameter stand rods. The tripod rods are fixed by hand with a short rotation of the knurled override. The SPV 12-3 /...
- Including Collets for 12 mm pipes
- Diameter: 250 mm
- Height (without SPV): 38 mm
Double clamp To upgrade from mono to MS stereo microphone
- To upgrade from mono to MS stereo microphone
Schoeps Cut 60, active Low Cut Module for Schoeps Colette Microphe systems, 60 Hz, 24dB/Okt., colour grey, length 17mm
Todos os preços são apresentados com 23% de IVA português e válidos até ruptura do stock. Os portes de envio para Portugal continental têm o valor de 20,-EUR. Para encomendas de valor igual ou superior a 199,-EUR os portes de envio serão gratuitos. Para mais informações sobre o envio e entregas para outros locais, por favor clique aqui. Não assumimos responsabilidade por eventuais erros tipográficos ou informação imprecisa de qualquer tipo. *UVP = Preço de venda recomendado pelo fabricante / distribuidor para venda na Alemanha.