EMG BTS System

I was undecided between the EMG BTS and the BQC System. The 3-band semi-parametric midband looked appealing.

Until I read about the DIP switches of the BTS System and the way they change the Treble band EQ lines. Essentially, the DIP switches make the Treble control act like a treble boost/cut (2 different center frequencies) or like a high-mid boost/cut (again, with 2 different center frequencies).

So, once installed (and the included instructions make it easy as a few cable clicks), you can basically dial-in any tone curve you need in a matter of minutes! This is truly a case of "less is more".

The included knobs aren't the prettiest, but they're ok. You can always swap them for others that suit your taste better. (I won't bother.)
Also, on looks-wise, no "concentric ugliness" on this system!

Being a modular system, you can always buy other individual EMG systems to better suit your needs and likings. But you will be more than served with this one!

I fitted this as an upgrade (along with a set of EMG PJX pickups) to my Epiphone EBM-4 bass. The original setup utilised passive pickups with active electronics. The pre-amp board went on the original, so I decided to overhaul.

Instant new bass, I?m really happy with the results. The sound quality is far superior compared to the original setup. The bass and treble controls provide a nice level of boost/cut and the internal dip switches allow for additional tonal options.

I opted for an 18v power configuration, this required a little soldering. Well worth opting for the higher voltage supply as it ensures a really strong signal. You will need a second battery clip for this, only one is provided with the kit.

My output jack was a long barrel style one and I also had to solder its connections.

Pros:
Easy to install due to the quick connect system
Very clear instructions
All materials required were provided, including some shrink tubing if you have to solder like I did.

Cons:
These have long pot stems which didn?t fit 100% as planned however was overcome with some washers, so no big issue.

Verdict:
I?m very pleased with my purchase. It arrived on time and allowed for a hassle-free installation. A quality product, would highly recommend this.

I fitted this unit as an upgrade (along with matching EMG pickups) to a bass I had made. The sound and quality is obviously far better than the original generic system I used and the connectors mean that it was fuss-free to fit. The bass and treble controls provide pleasing amounts of cut and boost at very sensible frequencies.
It came with perfectly adequate instructions showing various different configurations and there is also information on the EMG website.

My BCRich came with the original soldered EMG units, which I love. after the original FX processor went some years later, I decided to stick to the same sound but had to purchase the whole pot set and fx processor since it's now prewired and uses the solder less connections. The use of the solder less connections made the refitting that much easier and would have been a breeze if it weren't for the fact that the instructions didn't have my particular wiring setup. Also the pot stem length seems to be shorter than the original which resulted in some minor modifications to the bass body, something purest's perhaps wouldn't like to find out after purchase.