- With 4 rows and 4 columns
1–2 de 5 comentáriosLer todas as reviews
Did you know it can also work as a sequencer?
The heart of my sequencing rig
As a straight forward mixer, you can mix up to four signals and route them to four separate outputs, and each output can be set independently to sum the signals in a unipolar (positive voltage only) or bi-polar (positive and negative) fashion. Leaving the first input unplugged also allows you to add an offset to each output via the top row of knobs - very useful!
Where this unit comes into its own however is as a sequencer - you can create four separate sequences from the same input voltages - which can then be used to drive four oscillators to give some nice chords, or if you add an A-151 sequential switch (recommended!) you can create much longer and more complex sequences by switching between the outputs and sending them to one oscillator.
You can also mix LFOs / envelopes etc to create interesting and evolving modulation sources.
You can even (very carefully!) feed the outputs back into the mixer and use it for 'zero-input-mixer' music (disclaimer - feedback is tricky to control! Be careful!)
The usual high Doepfer standards apply here, the perfect blend of affordability and usability.
Matrix Mixer With 4 rows and 4 columns
Standard VCO for Modular System A-100Module A-110-1 (VCO) is a voltage controlled oscillator. The A-110-1 produces frequencies in a range of about 8 octaves, of which four waveforms are available...
Wasp Filter Special edition, Black front, Yellow knobs
ADSR Envelope Generator The module A-140 is a envelope generator and since it delivers control voltages, belongs to the modulation-modules. As soon as the ADSR is triggered at gate-input, it...
Passive Multi-Port Distributor 8x Interconnected jacks, Sockets are divided into 2x quadruple groups; but can also be modified to an eight-multiple (soldering bridge on the circuit board), Width:...
Mixer ModuleModule A-138 is a four-channel mixer that can be used for mixing control voltages as well as for mixing audio signals. A separate attenuator is available for each of the four inputs. In...
Quad ADSRThe module contains 4 independent ADSR envelope generators. Each sub-module has the controls Attack, Decay, Sustain and Release. With the 3-stage range switch, the desired time range can be...
Module Dual linear/exponential, VCA
Doepfer A-100 LC1 Low Cost Case for Eurorack Modules; build-in Power Supply A-100SSB (+12V/380 mA, -12V/380mA); 48 TE Version of the A-100LC3; build-in Bus Board with 8 Module connectors; Housing...
Spring Reverb ModuleDoepfer A-199 is a spring reverb module, which electronically simulates the reverb effect with the aid of spiral springs. Spring reverb systems have a characteristic sound...
Doepfer A-180-3 Dual Buffered Multiples, dual buffered 1-in-3 multiple to copying/buffering of control and audio signals, Width: 4 TE / 4HP / 20.0 mm
Doepfer A-111-2; High End VCO II / VCLFO; Width: 14 HP, Current: +70mA (+12V) / -50mA (-12V)
External Input / Envelope FollowerModule A-119 is used to integrate external audio signals into the system A-100, and includes the components pre-amplifiers, envelope follower and a comparator. The...
Filter 12 dB Multi-mode filter, in which the circuit of the SEM module is used, Width: 8HP 40.3 mm, Depth: 55 mm (measured from the rear of the front panel), Power requirements: +30 MA (+ 12V) /...
Noise/Random Voltage Generator Module A-118 is a noise and random voltage generator. It produces the following signals: white noise, coloured noise, and random voltage. White and coloured noise can...
VCA (Voltage Controlled Amplifier)The A-131 module is a voltage-controlled amplifier. An exponential VCA (A-131) is usually used for audio applications, while a linear VCA (A-130) is used for...
Doepfer A-157 Trigger Sequencer Subsystem 1-2-3, contains: A-157-1 Trigger Matrix (8x16) + A-157-2 Output Module and A-157-3 Input Module, generate up to eight trigger signals controlled by a 8x16...
Wasp Filter Module A-124 is a special 12 dB multimode filter using the "strange" filter circuit of the "EDP Wasp" (an analog synthesizer with black/yellow case built end of the seventies,...
Analog and Trigger Sequencer for Modular System A-100 The following functions are available for the two analog rows (rotary knobs): 8 Rotary potentiometers, Scale (stepless knob) on the lower...
Dual QuantiserThe A-156 Module is a dual control voltage quantiser. A quantiser converts a continuous input control voltage in the range of 0 ... 10V into a stepped output voltage in the same...
Basic VCO for the A-100 modular system Voltage controlled oscillator, 3-Position toggle switch, Linear FM input and soft-sync input, Tune control range can be set between approx. 1/2 octave and 4...
|Número de artigo||240112|
|Unidade de venda||1 peça|
|Disponível desde||Dezembro 2009|
|ranking de vendas|
|nesta categoria||Classificação 110|
|em thomann.de||Classificação 17363|
- Indicar Doepfer Sintetizadores modulares
- Sintetizadores modulares Indicar na faixa de preços de 120 € - 160 €
- para o grupo de produtos Sintetizadores modulares
- para o grupo de produtos Sintetizadores
- para o grupo de produtos Teclados
- Mostrar Informações do fabricante sobre Doepfer
- Doepfer Teclados em resumo
- Versão de impressão desta página