Palmer Visão geral de produtos
115 Acertos. Visualizando artigos 51–75.
Todos os preços incl. IVA Frete grátis a partir de € 199
Não foram encontrados resultados :-(
Um dos filtros usados está a funcionar tão bem que não foi encontrado nenhum produto!
Um dos filtros usados está a funcionar tão bem que não foi encontrado nenhum produto!
Poderá remover os filtros e começar novamente ou utilizar o filtro seleccionado anteriormente.
Load Box Format: 9.5''/ 1 RU, Adjustable in 6 steps (100%, 70%, 50%, 35%, 25%, 18%), Reduces the volume of a guitar speaker at full saturation of the tubes, Made for 16 Ohm loudspeakers, Bypass/ attenuator switch for fast...
- Format: 9.5''/ 1 RU
- Adjustable in 6 steps (100%, 70%, 50%, 35%, 25%, 18%)
- Reduces the volume of a guitar speaker at full saturation of the tubes
Serial Power Distribution 6 Connections, Cable length between the outputs: 350 mm, Maximum length: 2.3 m, Input connector: inner hollow sleeve 5.5 x 2.1 mm, Output Connections: indoor coaxial power connector 5.5 x 2.1 mm (9.5 mm shaft length)
- 6 Connections
- Cable length between the outputs: 350 mm
- Maximum length: 2.3 m
Y-Box Guitar SplitterPALMER Y-Box, splitbox for guitar signals. "When I am connecting the inputs of my two amplifiers, there is a strong hum." A frequent query in the technical section of relevant specialist magazines. The solution to this problem is...
- Clinking input with 1 Mohm input impedance
- Output AMP1 as parallel circuit
- Output AMP2 is electronically converted with a subsequent transformer stage
Palmer Pro RMMS 8, low-noise microphone splitter 19", 8 XLR inputs (balanced), each input linked onto one direct out and one transformer isolated output, combine two channels to double or to sum up outputs, ground lift on each channel, fits...
Passive 4 channel line splitter Nominal impedance 600 ohms, Max. input +20 dB, 19" / 1U, On the front of each channel: 1 Input + 1 thru (for phantom power transmission), 2x isolated outputs, 5 Year warranty
- Nominal impedance 600 ohms
- Max. input +20 dB
- 19" / 1U
Pocket Preamp for Electric Guitar MK 2 - Completely revised version, Offers an extended range of all "official" tube amp sounds -from absolutely clean to extremely high gain, Three-way switch for amplifier characteristics, Gain Mode and Microphone Position, Control:...
- MK 2 - Completely revised version
- Offers an extended range of all "official" tube amp sounds -from absolutely clean to extremely high gain
- Three-way switch for amplifier characteristics
Guitar DI-box and speaker simulation Joe Bonamassa Signature Model, JB switch: Off / Medium / Heavy - behaves like a mid boost, Attenuator: 24/12/0 db, Deep / Normal / Flat voicing switches, Bright / Normal / Mellow voicing switches,...
- Joe Bonamassa Signature Model
- JB switch: Off / Medium / Heavy - behaves like a mid boost
- Attenuator: 24/12/0 db
Independent Battery Power Supply for Effect Units Capacity: 4000 mAH, Durable Lithium Polymer battery, Two regulated 9V DC outputs with each 500 mA, USB-A port for charging a phone or tablet, 5-Segment battery status indicator, Flat metal housing for...
- Capacity: 4000 mAH
- Durable Lithium Polymer battery
- Two regulated 9V DC outputs with each 500 mA
Protective cover Suitable for Palmer 1x 12" cabinets and Palmer Fat 50 1x 12" combo, Material: Nylon, Dimensions (W x D x H): 580 x 290 x 450 mm, Weight: 200 g, Colour: Black
- Suitable for Palmer 1x 12" cabinets and Palmer Fat 50 1x 12" combo
- Material: Nylon
- Dimensions (W x D x H): 580 x 290 x 450 mm
Microphone split box 2-Channel splitter box 1" in 3", Aluminium diecast housing, Per channel: One XLR input (female) parallel jack, XLR (male), two XLR outputs (male) via an isolating transformer 1: 1, Nominal level: 0 dB, Maximum level: +20...
- 2-Channel splitter box 1" in 3"
- Aluminium diecast housing
- Per channel: One XLR input (female) parallel jack, XLR (male), two XLR outputs (male) via an isolating transformer 1: 1
Bass Effect Pedal Chorus, Regulator: Rate, Depth & Intensity
- Regulator: Rate, Depth & Intensity
Stereo Press Box Audio Splitter 2, Is used for press conferences, in order to distribute 1 speech microphone to 20 sending stations or recording devices galvanically separated, 2 Line inputs: XLR / female optionally mono-summable, GND lift switch, Outputs:...
- Audio Splitter 2
- Is used for press conferences, in order to distribute 1 speech microphone to 20 sending stations or recording devices galvanically separated
- 2 Line inputs: XLR / female optionally mono-summable
Passive Mono DI BoxPalmer ADIG-LB is the consistent further development of our legendary speaker simulator PDI03, which has proven itself worldwide in the recording studios and by well-known artists such as Keith Richards / Rolling Stones, Alex Lifeson / Rush,...
- Loadbox: jack input for loudspeaker signal with parallel jack for looping the signal, if a loudspeaker box is to be connected (as monitor in stage operation).
- Input impedance of the load box: 8 Ohm, max. Input power 120 W RMS
- Display of input power: 6-pin LED chain
Bass Preamp For practicing, recording and performing, For active and passive basses, 3 Sound modes: Clean, Overdrive and Fuzz, 3-Band equalizer which has been specifically tuned for bass guitar and with semi-parametric mid control, Output DI or with speaker...
- For practicing, recording and performing
- For active and passive basses
- 3 Sound modes: Clean, Overdrive and Fuzz
Line summer/merger, isolated signal combiner When mixing electrical signals, the sources can affect each other. Decoupling resistors can reduce the effect, but lossless mixing is only possible with an active circuit. Active electronics always involve some extra effort and...
- Input 1: Balanced XLR/f via a galvanically isolated transformer. Balanced decoupling via resistors. Total resistance: 2 kOhm
- Maximum sound level for THD <0.5% @ 35 Hz: +20 dBu. Ground lift switch
- Input 2: Balanced XLR/f. Balanced decoupling is via resistors. Resistance: 2 kOhm
2- Channel Reactive Load Box 2 Jack inputs, Mono/ stereo mode, Impedance: 2x 8 Ohm/ 1x 16 Ohm/ 1x 4 Ohm, Max. load: 2x 100 W/ 1x 200 W, SIze: 19"/ 1 RU, Dimensions (W x D x H):...
- 2 Jack inputs
- Mono/ stereo mode
- Impedance: 2x 8 Ohm/ 1x 16 Ohm/ 1x 4 Ohm
Electric Guitar Speaker 2x 12" Celestion G12M Greenback speaker, Closed design, Power rating - Mono: 50 W; Stereo: 2x 25 W, Impedance - Mono: 8 Ohm; Stereo: 2x 16 Ohm, 2x 6.3 mm Jack sockets, Cabinet material: Chipboard, Baffle...
- 2x 12" Celestion G12M Greenback speaker
- Closed design
- Power rating - Mono: 50 W; Stereo: 2x 25 W
Power Conditioner Specially designed for effect devices and pedalboards, Eliminates or reduces noise induced by inferior power supplies, Input and output: 2.1 x 5.5 mm barrel socket, negative polarity inside, Automatically detects the polarity of the connected power supply...
- Specially designed for effect devices and pedalboards
- Eliminates or reduces noise induced by inferior power supplies
- Input and output: 2.1 x 5.5 mm barrel socket, negative polarity inside
Effect Pedal Delay, Controls: Time, Mix and Rate, Power consumption: 30 mA, Dimensions (W x D x H): 60 x 100 x 55 mm, Battery operation possible, Matching power supply: Art.409939 (not included)
- Controls: Time, Mix and Rate
- Power consumption: 30 mA
Passive monitor controller in robust metal housing Real wood edges, 2x Jack/XLR combo input, 1x 3.5 mm Stereo jack input, 2x XLR male output, 1x 3.5 mm stereo jack out, Switchable mute, Switchable mono-summing, Dimensions: 164 x 62 x...
- Real wood edges
- 2x Jack/XLR combo input
- 1x 3.5 mm Stereo jack input
Active Mono DI Box Inputs: 6.3 mm jack and XLR female, Parallel 6.3 mm jack output, XLR male output, Pad switch (-10 dB / -20 dB / -30 dB), Switchable gain boost: +12 dB, Switchable ground lift, Operates with...
- Inputs: 6.3 mm jack and XLR female
- Parallel 6.3 mm jack output
- XLR male output
Palmer Octobus 8-Speed effect looper, 32 Programmable presets, True Bypass, 300 mA Power consumption (9V power supply included), Measurements (W x H x D): 455 x 110 x 45 mm
- 8-Speed effect looper
- 32 Programmable presets
- True Bypass
Studio Headphone Amplifier Reference class headphone amplifier, Stereo mono or dual mono operation, 2 x 6.3 mm Headphone outputs, Suitable for headphone impedances of 8 - 200 Ohm, Robust 9.5" metal housing, XLR / jack combi-inputs, XLR loop out,...
- Reference class headphone amplifier
- Stereo mono or dual mono operation
- 2 x 6.3 mm Headphone outputs
2 Channel merge box for microphones 2x XLR female in 1x XLR male out, Balanced decoupling, Also suitable for condenser microphones, Impedance 200 ohm, Completely passive circuit, Dimensions 110 x 73 x 42 mm, 5 Year warranty
- 2x XLR female in 1x XLR male out
- Balanced decoupling
- Also suitable for condenser microphones
Line Summing / Merger 2 Channel active summed e.g. 2 mixing consoles to 1 PA system, Adjustable output volume, Switchable pad, Mute and mono per channel, XLR / Combi input, XLR Input, XLR Output, Internal power supply, Format: 9.5"/...
- 2 Channel active summed e.g. 2 mixing consoles to 1 PA system
- Adjustable output volume
- Switchable pad
Todos os preços são apresentados com IVA português, à taxa em vigor e válidos até ruptura do stock. Os portes de envio para Portugal continental têm o valor de 20,-EUR. Para encomendas de valor igual ou superior a 199,-EUR os portes de envio serão gratuitos. Para mais informações sobre o envio e entregas para outros locais, por favor clique aqui. Não assumimos responsabilidade por eventuais erros tipográficos ou informação imprecisa de qualquer tipo. *UVP = Preço de venda recomendado pelo fabricante / distribuidor para venda na Alemanha.