Artec SE-2A Bass Electronic Set

108

Bass Electronics

  • With 2-band EQ on tandem knobs
  • To connect to active or passive pickups
  • 3 Knobs for treble - bass and tandem (volume)
  • Bass: +/- 12 dB @ 100 Hz
  • Treble: +/- 12 dB @ 4 kHz
  • Matching potentiometer knobs: art. 339884 and art. 339886 (not included)
Disponível desde Agosto 2004
número de artigo 172727
unidade de venda 1 peça(s)
Equalizer 2-Band
€ 23,90
IVA incluído, € 20 de portes de envio adicionais
Em stock
Em stock

Este produto encontra-se em stock e pode ser enviado imediatamente.

Informações sobre o envio
Envio previsto até Sexta, 26.04.
1

108 Avaliações de clientes

4.1 / 5

Terá de iniciar sessão para classificar produtos.

Nota: De forma a prevenir que as classificações sejam baseadas em boatos, conhecimento limitado ou má publicidade nós apenas permitimos classificações provenientes de clientes no nosso website, que tenham adquirido o equipamento através de nós.

Após iniciar sessão poderá encontrar todos os produtos que poderá classificar em classificar produtos no centro de clientes.

som

acabamento

75 Críticas

t
touro166 13.07.2021
eu gosto deste preamp,ja usei antes em outro baixo que tive,e bem satisfatorio,recomendo pos resolve bem o problema...como no meu caso gosto do som mais gordo e alto das saidas dos caps para poder assim usar de melhor forma as frequencias...
som
acabamento
0
0
Reportar a crítica

Reportar a crítica

AS
Custo benefício
Allan SpaceBuzzTrio (Lisbon) 11.11.2022
Faz o que promete. Interessante para upgrade em baixos low cost
som
acabamento
0
0
Reportar a crítica

Reportar a crítica

google translate gb
Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
W
Preamp good but watch the wiring
Woodinblack 17.01.2018
I fitted this on a previously passive Iceman bass. The shafts of the pots aren't long, so I had to do a bit of woodwork and the width of the dual concentric tone control is bigger than a normal tone knob, so the hole needed to be rewired. They give you a good amount of cable to position the battery.

I had a problem in that after grounding the bass, it no longer made any noise and found out that the wires that went from the balance output to the tone input were reversed which was shorting out the board. Taking the pins out of the plug and putting them in correctly (as the silk screen on the board shows) fixes the problem. Also note that there are no instructions with these preamps, although instructions are on artecs website. Everything is wired (even if incorrectly) apart from battery +/- and jack out/ground/switch solder terminals on the board.

Apart from the wiring issue, which is why I marked quality down, the actual quality of the preamp is fine, I can hear no difference with it in or out of the circuit with the tone controls flat, as it should be, and the tone controls provide a useful range of options.
som
acabamento
3
1
Reportar a crítica

Reportar a crítica

google translate gb
Infelizmente ocorreu um erro. Por favor tente novamente mais tarde.
C
Good upgrade!
Cesar593 13.10.2017
This is a noise free, reliable and very well built active preamp for bass guitar! I have used it to replace a noisy preamp in an older bass, and I am very satisfied! Not only did the noise disapear, but it now sounds louder and deeper. Don't be fooled by the price, this is a great preamp! Best for the buck out there, no doubt about it!
som
acabamento
5
0
Reportar a crítica

Reportar a crítica