EMG 1 or 2 Pickups HZ Wiring Kit, includes everything needed for the installation of 1 or 2 passive EMG soldeless pickups, split shaft potentiometers (standard length), includes 2x volume pots, 2x tone pots, 1x pickup buss, 1x power buss, 1x 12B output jack with battery clip, 1x output cable, 4x interconnect cables and 2x pickup cables, only for passive pickups
I bought a set of EMG 40HZ for a bass and since I didn't wanted to bother with all of the soldering I decided to go with EMG's solderless install (40HZ didn't included any of the quick install components, unlike active EMG pickups).
The whole idea with a solderless install is really great. It took me less than 15 minutes to get everything working. Default connectors are wired for serial humbucker connection. But with spare EMG connector cable and 2-pin connectors you can easily change the connection type (I got 2 spare cables with my pickups that was used for split-coil hum-cancelling connection type).
Wiring kit is also compatible with any other passive pickups. The only thing you need to get it working is connecting 2-pin connector to the pickup cable instead of soldering it.
The only downside of the Wiring Kit I got, was the wrong wiring on one of the pickup cables. It took me a while until I finally measured pickup resistance on the connection cable and understood that 2 wires on the connector were out of place and pickup was working in single coil mode as a result. Fortunately it wasn't too hard to switch a few wires and get a perfectly working humbucker in the end.
I think this was just an isolated error, but in case anyone got some volume problems - check cable wiring first.
* Ceny zawierają podatek VAT. Do ceny artykułu(ów) należy doliczyć koszty wysyłki. Oferty ważne do wyczerpania zapasów. Za błędy w opisie i innego rodzaju pomyłki nie ponosimy odpowiedzialności. CK=Cena katalogowa produktu