Adam Hall 87222STL U-Rack Panel 2U

299

U - Rack Panel

  • 1.2 mm steel
  • Format: 19 " / 2U
  • Colour: Black
Produkt dostępny od Sierpień 2008
Numer artykułu 214130
Jednostka sprzedaży 1 szt.
Rack Units 2 U
Type 19"
20,70 zł
Zawiera podatek VAT, nie zawiera kosztów wysyłki 49 zł
Dostępny w magazynie
Dostępny w magazynie

Produkt jest dostępny w magazynie.

Informacje dotyczące wysyłki
Szacowana dostawa pomiędzy Środa, 24.04. and Czwartek, 25.04.
1

299 Oceny klientów

4.9 / 5

Aby wystawić opinię, należy się zalogować.

Informacja: Aby opinie na temat sprzętu umieszczane na naszej stronie pochodziły jedynie od osób mających styczność z danym artykułem, umożliwiamy wystawianie ocen jedynie naszym klientom.

Opinie można wystawiać po zalogowaniu się w centrum klienta, używając opcji "wystaw opinię".

wykończenie

87 Opinie

google translate gb
Wystąpił błąd. Proszę spróbować później.
K
Thick and strong.
Karmo7 08.03.2020
I made my own I/O panel out of this.
It has i matte black finish, in case you are not a fan of glossy things.
It's made of steel. Strong and sturdy. No dents or defects were caused by drilling the holes. I fitted 24 type-d XLR sockets on this.
wykończenie
1
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
I
The right one to fill the empty space..in your rack
I'mTheSoundGuy 23.10.2019
As I stated above, this 2 U panel is the perfect solution when you want to close a gap on you rack. I use it in an IEM/Wireless mics rack where I have 2 units left and it hides the cables inside the rack. Solid construction with no bending because of the 90 degrees dented lower side. Great product!
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
P
Good quality 2U panel and very strong
Pete-plays-guitar 25.04.2017
There is not a lot you can say about a 2U rack panel, but I will have a go.

One major thing (I think is major) is that the end of the strip top and bottom is bent over at 90 degrees with makes this a very stiff and strong panel, especially when combined wit the fact that is it a quite heavy gauge steel it is pressed from. Many rack strips have no bent edge which makes them flex and this starts to make the paint crack, so no problem with this one.

Once fitted int the rack, it is rock solid. I would also have no problems in drilling into this strip for fitting plug sockets etc.

Highly recommended
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
D
Standard 2U blanking plate
David9374 20.07.2019
Very useful to improve the appearance of your rack if you have spaces. Could spray paint a logo on it if you wanted to customise your rack too.
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie