Met onze cookies willen we u de best mogelijke winkelervaring bieden met alles wat daarbij hoort. Hieronder vallen bijvoorbeeld passende aanbiedingen, gepersonaliseerde advertenties en het onthouden van voorkeuren. Als u dit goed vindt, ga dan eenvoudig akkoord met het gebruik van cookies voor voorkeuren, statistieken en marketing door op “Oké!” te klikken. (show all). U kunt uw toestemming op elk moment nog intrekken via de cookie-instellingen (hier).
Note: Om te voorkomen dat evaluaties gebaseerd zijn op roddel, geruchten of heimelijke advertentie staan wij op onze website alleen evaluaties toe van daadwerkelijke gebruikers die het geevalueerde product bij ons gekocht hebben.
Na inloggen vindt u alle producten die u kunt evalueren ook onder “Product evalueren” in uw klantencentrum.
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
A
Schaller - TOP quality
Anoniem 07.08.2016
Schaller products are top quality, very accurate. As I built my dream guitar, it was very important to have all details in high quality, therefore I chose this Schaller tailpiece and some other details from Schaller as well. I would definitely recommend this tailpiece to everyone who is concerned about quality of the product.
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
AF
Nice quality but the bushings are small and not universal-threaded
Andy Fereday 10.02.2022
I found this stop tailpiece to be a nice quality - the powder coating was uniform and there's a good weight to it. I bought it to replace an existing bridge but found the bushings were noticeably smaller. The thread in the posts was tighter than the thread in the existing bushings, so I couldn't simply switch out the posts as they didn't fit.
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
m
Not as good as epiphone stop tail
meelo 28.08.2019
This stop tail doesn't lock into the installation pegs while strings are off, so this drops off very easily when strings are entirely removed for more comprehensive cleaning.
Installation pegs were also too short for the original holes I had in Epiphone SG, so I had to install the stop tail quite low compared to the old one. Would be nice if Schaller had extra selection of installation pegs for this and their bridges.