• Verlanglijst
  • nl
    Winkel kiezen Select Store
    Alle landen All Countries
  • 0

De grote online raadgever van Thomann: Flutes

5. The Mechanism

The mechanism or ‘keywork’ of the flute is found on the body and footjoint - the keys are depressed with the player’s fingers onto the ‘tone-holes’ of the flute in order to change the pitch that is produced.

Unlike the tone-holes of wooden instruments, which are normally carved into the body of the instrument, the tone-holes of the modern flute are either extruded or ‘drawn’ from the body of the tube, or soldered directly onto the tube. In both cases, the tone-holes protrude from the tube by around 5mm at their highest and 1mm at their lowest.

Drawn tone-holes are made by a machine which extrudes them from the tube of the instrument through the use of heat and spinning ball-bearings, and then rolls the top of them down until they are flat and even.

Soldered tone-holes are soldered to the tube by hand, which is a labour intensive and time consuming job. Drawn tone-holes are therefore usually found on most student and mid-range instruments, and it is generally only handmade instruments played by professionals that are made with soldered tone-holes.

Uw contactpersoon
Tel: +49-9546-9223-26
Fax: +49-9546-9223-24
Krijg gratis Hot Deals!

Meer dan 8.100.000 musici/muzikanten lezen deze al: de Thomann Hot Deals. Krijg nu uw gratis exemplaar met meer dan 500 actuele aanbiedingen!

Hot Deals
Wat een Thomann-fan over ons zegt
Uiterst tevreden over deze pagina en ben over de klantenservice ook erg tevreden. Complimenten!
xxxja20k@xxxil.com, 07.07.2015

in de Überblick

(2)
(2)
(3)
(3)
(1)
Feedback

Fout gevonden of wilt u feedback geven op deze pagina?

We kijken er naar uit om van u te horen en proberen elk probleem zo snel mogelijk op te lossen.

Annuleer