• Verlanglijst
  • Winkel kiezen Select Store
    Alle landen All Countries
  • 0

De grote online raadgever van Thomann: Cables, Leads & Connectors

7. Loudspeaker Cables

The main function of a speaker cable is to provide a low-resistance path between the amplifier and the loudspeaker. To do this well, a hefty cable made of a pure metal (such as oxygen free copper) is best, but if you're on a tight budget, 30A cooker cable works pretty well! Cable runs should be kept as short as possible, and each speaker in the system should be connected to the amplifier by cables of equal length. Speaker cables require no screening.

Connectors

The most common way to connect a passive (non-powered) speaker is a speakon cable. These are normally found in high power and pro systems. Speakon leads come ready-made in a range of different lengths.

Speaker leads comes also with 1/4-inch jack and 3-pol XLR connectors. Another way to connect a passive speaker is to use bare-ended, 2-core wire, clamped at both amplifier and speaker ends using threaded posts which are tightened and loosened using the fingers. Note that positive and negative connections are denoted by red and black respectively. Always observe the correct polarity to avoid phase problems.

Uw contactpersoon
Tel: +49-9546-9223-35
Fax: +49-9546-9223-24
Krijg gratis Hot Deals!

Meer dan 7.900.000 musici/muzikanten lezen deze al: de Thomann Hot Deals. Krijg nu uw gratis exemplaar met meer dan 500 actuele aanbiedingen!

Hot Deals
Wat een Thomann-fan over ons zegt
Pakket in goede orde ontvangen en snel, dat is klasse! Hiermee laten jullie toch wel zien dat je een betrouwbare parnter bent.
theofelxxxnn@gmxxx.com, 27.03.2014

in de ‹berblick

(2)
(1)
(1)
Feedback

Fout gevonden of wilt u feedback geven op deze pagina?

We kijken er naar uit om van u te horen en proberen elk probleem zo snel mogelijk op te lossen.

Annuleer