EMG J5 Set

18

Actieve pick-upset

  • Voor 5-snarige J-Style elektrische bas
  • Output: Medium
  • De originele EMG J-set voor basgitaren met 5 snaren, welke meteen een succes werd met zijn harmonische boventonen, druk en weinig ruis
  • Klassieke jazz bass karakteristiek met een breder geluidsfrequentiebereik
  • Verbindingen: soldeerloos
  • Magnetisch materiaal: keramiek
  • Capkleur: zwart
  • Gemaakt in de VS.
  • Inclusief: EMG exclusief Solderless (soldeerloos) installatiesysteem: 2x 25k volume poti, 1x 25k toon poti, 1x batterijbus, 1x stereo output socket, 4x paar bevestigingsschroeven, 2x pickup kabel, 2x aansluitkabel, 1x output kabel, 1x accukabel
Leverbaar sinds Oktober 2017
artikelnummer 419028
verkoopseenheid 1 stuk
Active Pickup System Yes
Wiring pre wired
Colour Black
Position Bridge, Neck
€ 166
alle prijzen incl. btw
direct leverbaar
direct leverbaar

Dit product is op voorraad en kan direct verzonden worden.

Informatie over de verzending
Gratis verzending verwacht tussen Dinsdag, 2.04. en Woensdag, 3.04.
1

18 Klantenbeoordelingen

4.8 / 5

U moet ingelogd zijn om producten te evalueren.

Note: Om te voorkomen dat evaluaties gebaseerd zijn op roddel, geruchten of heimelijke advertentie staan wij op onze website alleen evaluaties toe van daadwerkelijke gebruikers die het geevalueerde product bij ons gekocht hebben.

Na inloggen vindt u alle producten die u kunt evalueren ook onder “Product evalueren” in uw klantencentrum.

geluid

afwerking

14 Recensies

FB
Very nice upgrade
Frank B. from H. 26.03.2023
While my Aria RSB 618-5 is a well built bass for the money (and since Thomann have copied this model for their own HB brand Aria must be doing something right) the electronics are, erm, well, not stellar. I replaced them with an EMG J5 set, and it takes the instrument to a whole new level. There are a few things to consider though.

If your bass has a pick guard, you may have to enlarge the pickup hole a bit. The battery also roams around unchecked in the control area so a clamp or similar device to constrain it is required. I had to slightly widen the routes from the pickup cavities to the control area: 5.5 mm is the absolute minimum diameter required for the connectors to go through. Furthermore, you get everything in the package except pick up springs. Keep your old ones around because you’ll need them. You also may or may not need new knobs.

Despite these minor gripes it’s a definite and serious upgrade. Installation was not too hard if you work slowly and concisely. It is indeed a solderless solution.
geluid
afwerking
1
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
Rv
very bright; good definition; lesser growl
Rob van Dijk 22.01.2019
Have put them on a Yamaha BB415 (with P+J pickups). After some woodchopping I mounted them on 5cm and 15cm from the bridge. This 1:3 distance I've calculated to be the best to get all overtones in a nice balance. I play with fingers; jazz, funk/soul and some pop; some slapping. Neck sec sounds fat and bright; very usable. Bridge sec needs some equalizing in lows. However, Br + Nk and in particular Br + 50% Nk give a great balanced sound on all strings. Br + Nk with tone full open give a nice fat+snappy sound for slapping. Compared to the original pu's the sound is deeper and much brighter, but I miss some growl. With an equalizer on 250Hz (1 octave) it is OK. The brightness tends to be too much. My strings are more than half a year old and it still needs the tone control at half. I use a Hartke HD75 with a warm sound, which works fine with the J5's. But with a bright amp+speaker it might get too much.
Installation was pretty easy, however I am not very pleased with the configuration options. See the J5-instructions at the EMG-website. There are 4 setup-configurations: (1) Passive with 2x volume; (2) Active with a balance control (not supplied; $79?) with 1x volume; (3) Active with pu-switch (not supplied) and 1x volume; (4) Active with pu-switch (not supplied) and 2x volume. At all 4 there is also a tone-control. With the supplied components only '1' can be made. When having a switch '3' and '4' are possible. '2' (which I preferred) needs an additional control (for which I asked EMG, without answer upto now). For using a switch you need some soldering. The volume controls have the most effect in de last quarter of the turning range. Not optimal. The tone-control works fine, upto a dark reggae sound.
The end result is better than what I had, but all together not ultimately satisfied because of the controls and the lack of growl. Maybe the Yamaha (wood) itself gives already a bright sound and/or the original pu's were not so bad at all. And I still want to have a balance control.
geluid
afwerking
0
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
GJ
one of best jazz bass pickup available in the market
Gab Johnny DeTo 13.10.2020
simply, fantastic.
silences, balanced and very dynamic.
little tips: I had to struggle for a moment to fit the 9v battery into the electronics housing of my jazz, but in the end I managed it without having to make any changes to the body.
If you want transform your jazz bass in active, i strongly suggest this.
geluid
afwerking
1
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
KL
BEST EMG PICKUPS
Kieran Lochran 11.06.2021
Installed them into my girlfriend's 5 string bass, and they sound so much better than the stock pickups
geluid
afwerking
0
0
Evaluatie melden

Evaluatie melden

Geschikt van YouTube